Is there a 36" wide by 48" long clear floor space directly outside the shower for persons who use wheelchairs to approach and use the shower as shown in Figure 35(a) above?...
Search Results "Hand-Held Shower Unit"
-
1c
-
Requirement 6. Reinforced walls for grab bars.
that covered multifamily dwellings with a building entrance on an accessible route shall be designed and constructed in such a manner that all premises within covered multifamily dwelling units...
-
1d
Does the 36" x 48" clear floor space directly outside the shower extend at least 12" past the seat wall of the shower to allow for a seat-to-seat transfer from the wheelchair?...
-
11B-809 Residential dwelling units
[See subsections ...]
-
11B-809 Residential dwelling units
[See subsections ...]
-
4.21.3 SEAT
A seat shall be provided in shower stalls 36 in by 36 in (915 mm by 915 mm) and shall be as shown in Fig. 36....
-
MULTI-BEDROOM HOUSING UNIT
[DSA-AC] A housing unit, intended for use by students at a place of education, with a kitchen and/or toilet and bathing rooms within the unit, such as an apartment, or dormitory....
-
1134A.6 Showers
Showers required to be accessible shall comply with this section....
-
11B-608.2.2.1 Clearance
A 36 inch (914 mm) wide minimum by 60 inch (1524 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment. [2010 ADAS] 608.2.2.1 Clearance....
-
11B-608.2.2.1 Clearance
A 36 inch (914 mm) wide minimum by 60 inch (1524 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment....
-
MULTI-BEDROOM HOUSING UNIT
[DSA-AC] A housing unit, intended for use by students at a place of education, with a kitchen and/or bathroom(s) within the unit, such as an apartment or dormitory....
-
Speedflow Hand Dryer
No need to recess the unit into the wall. ADA Surfaced mounted. Also helps to qualify for LEED Credits, being GreenSpec listed....
-
608.2.3 Alternate Roll-In Type Shower Compartments
608.2.3 Alternate Roll-In Type Shower Compartments....
-
4.8 Outdoor Rinsing Showers
[See subsections ...]
-
iStorm Hand Dryer Informational Video
-
11B-809.10.6.4 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: Continuous reinforcement shall be installed in the walls of showers 30 inches (762 mm) maximum to 38 inches (965 mm) minimum...
-
11B-610.3.1 Rectangular seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall. The side edge...
-
11B-610.3.1 Rectangular seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall. The side edge...
-
Residential Dwelling Units with Communication Features: ADA Standard Section 809.5
Residential dwelling units required to provide communication features shall comply with 809.5....
-
11B-608.2.1 Reserved
ETA Editor's Note The transfer type shower compartments prescribed by 2010 ADAS 608.2.1 are not recognized as an accessible shower in California....
-
11B-809.6 Residential dwelling units with adaptable features
Residential dwelling units with adaptable features shall comply with Sections 11B-809.7 through 11B-809.12....
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
Residential Dwelling Units: ADA Standard Section 206.5.4
Section 206.5.4 covers scoping requirements in the most current ADA Standards for accessible routes to residential dwelling units.
-
Curbs [4.21.7]
Curbs [4.21.7] Curbs are limited to ½ inch (measured from the room floor and the shower floor) so as not to interfere with entry to the shower....
