The provisions for toilet paper dispensers at section 604.7 of the 2010 Standards require the dispenser to be located seven inches minimum and nine inches maximum in front of the water closet...
Search Results "Maximum Extent Practicable"
-
Toilet Paper Dispensers
-
11B-703.3.1 Dimensions and capitalization
TABLE 11B-703.3.1 BRAILLE DIMENSIONS MEASUREMENT RANGE MINIMUM IN INCHES MAXIMUM IN INCHES Dot base diameter...
-
Features of Accessible Parking Spaces
Access aisle width is at least 60 inches, must be at the same level and the same length as the adjacent parking space(s) it serves, maximum slope in all directions is 1:48, and access aisle...
-
11B-703.3.1 Dimensions and capitalization
TABLE 11B-703.3.1 BRAILLE DIMENSIONS MEASUREMENT RANGE MINIMUM IN INCHES MAXIMUM IN INCHES Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm)...
-
11B-703.3.1 Dimensions and capitalization
TABLE 11B-703.3.1 BRAILLE DIMENSIONS MEASUREMENT RANGE MINIMUM IN INCHES MAXIMUM IN INCHES Dot base diameter...
-
704.8 Allowable area of openings
The maximum area of unprotected or protected openings permitted in an exterior wall in any story shall not exceed the values set forth in Table 704.8....
-
405.2 Slope (Exception 2), 405.6 Rise (Exception)
The running slope of ramp runs must not be steeper than 1:12 and any ramp rise must be 30 inches maximum....
-
2.2.3 Functional Reach
Use of the electromechanical probe required manually digitizing the 3-D location of the maximum reach point after the cylinder was positioned (Figure 2‒3)....
-
4.3.8 Operating forces
For other types of operable parts, the upper limit for operating force should be retained at a maximum of 5 lbf (22 N) to accommodate 95% of the sample....
-
Accessibility - Flatness and Lippage
Mortar setting beds for concrete pavers and paving slabs Joint width between paving units with chamfers (See Figure I) Maximum 3/8 in. (10 rom) - The surface of the mortared joint...
-
Regulatory Impact Analysis.
the 1991 Standards are an appropriate baseline to compare the new requirements against, since they represent the current set of uniform federal regulations governing accessibility, in practice...
-
Regulatory Impact Analysis.
the 1991 Standards are an appropriate baseline to compare the new requirements against, since they represent the current set of uniform federal regulations governing accessibility, in practice...
-
The Reasonable Modification NPRM
Making reasonable modifications to policies and practices is a fundamental tenet of disability nondiscrimination law, reflected in a number of DOT (e.g., 49 CFR 27.11(c)(3), 14 CFR 382.7...
-
New and Altered Permanently Installed Amusement Rides
The Department notes, however, that the 2010 Standards will require modifications to existing amusement rides when a ride’s structural and operational characteristics are altered to the extent...
-
Proposed Section 36.309 Purchase of Furniture and Equipment (Preamble, Section-by-Section Analysis)
Equipment Section 36.309 of the proposed rule would have required that newly purchased furniture or equipment made available for use at a place of public accommodation be accessible, to the extent...
-
3. Modified Theaters
The modifications listed here are minimum modifications mandated under this Consent Order and to the extent that actual modifications include and exceed those listed here, they will be deemed...
-
Who Decides Which Aid or Service Is Needed?
“Walk-in” requests for aids and services must also be honored to the extent possible....
-
9. Broadening of Documentation Requirement for Undue Burden Exception
We proposed that an agency would be required to consider the extent to which conformance would impose significant difficulty or expense in light of the resources available to the program...
-
2.7 Comparing Visual Detection Rates and High Conspicuity Ratings for Detectable Warnings
To the extent that the sample of participants in this study is representative of pedestrians with visual impairments, the data shown in Figure 34 through Figure 37 may be used to choose...
-
Model Building Codes and Industry Standards
The Access Board’s 2004 ADA Accessibility Guidelines, upon which the current ADA Standards are based, have been harmonized to a significant extent with industry standards and model building...
-
Delta Elongated Toilet C43902-WH
Product Features and Benefits Maximum flush power while saving you money, Delta 1.28gpf WaterSense labeled toilets are virtually clog-free Features the exclusive SmartFit™ tank-to-bowl...
-
Symmons Metering Faucet without Temperature Selection S-61
Selection S-61SCOT® Built to Last The rugged design of our SCOT faucet features brass, bronze, and stainless steel functioning parts which are housed in a heavy-duty, cast brass body for maximum...
-
Verifone MX 915 Point of Sale Machine with Credit Card Reader
Maximum Performance, Minimal Space The MX 915 is designed to engage consumers in new ways with its full-motion video display and slim, space-saving design....
-
§ 382.45 Passenger information
Carrier personnel shall not require any qualified individual with a disability to demonstrate that he or she has listened to, read, or understood the information presented, except to the extent...
