facility,” for the reasons set forth above, DOT’s regulations (specifically, 49 CFR § 37.43(a)(1)) expressly require that the public entity shall make the alteration “in such a manner, to the maximum...
Search Results "Maximum Extent Practicable"
-
(C) NYCT’s interpretation of the ADA and DOT’s implementing regulations is too narrow.
-
Site Selection
or parts of them (whether they comply with the older standards or were built before the passage of the ADA) are altered, then the altered areas must comply with the new standards to the maximum...
-
36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
The standards will allow independent entry to, use of, and exit from the equipment by individuals with disabilities to the maximum extent possible....
-
11B-232.1 General
alterations are originally planned), provided that each substitute cell— i) Is located within the same prison site; ii) Is integrated with other cells to the maximum...
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
disabilities to firmly grasp the grab bars and support themselves during transfers: Grab bars with circular cross sections must have an outside diameter of 1¼ inches minimum and 2 inches maximum...
-
Addendum F: Relative Height Differences
Adjustable Height No Grab Bars/No Backrest Maximum Height (n=71) .300 3.5 5.00 9.00 13.7...
-
11B-809.8 Doors
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 4 inches (102 mm)....
- Magnuson Group SLOPE Waste Receptacles
- Seating Solutions ADA Platforms, Ramps & Stairs
- Hussey Seating Company Flip-Up Armrest
-
Adjustable Height Range Considered
The technical criteria allow the height of transfer surfaces to be either fixed or adjustable within the 17 inches minimum and 19 inches maximum range....
-
11B-1008.2.5.2 Elevated
The rise for any ramp run connecting elevated play components shall be 12 inches (305 mm) maximum....
-
1134A.8, Item 1
The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor....
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”. ...
-
1009.2.1 Pool Lift Location
Where multiple pool lift locations are provided, no more than one pool lift shall be required to be located in an area where the water level is 48 inches (1220 mm) maximum....
-
1009.5.4 Transfer Steps
Transfer step height shall be 8 inches (205 mm) maximum....
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz maximum...
-
407.8.2.2 Obstructed Side Reach
part is located more than 10 inches (255 mm), but not more than 24 inches (610 mm), beyond the vertical reference plane, the height of the operable part shall be 46 inches (1170 mm) high maximum...
-
11B-405.3 Cross slope
Curved ramps are not prohibited by Chapter 11B; however, requirements for maximum slope and cross-slope cannot be exceeded. ◼...
-
4.10.12(3)
All floor buttons shall be no higher than 48 in (1220 mm), unless there is a substantial increase in cost, in which case the maximum mounting height may be increased to 54 in (1370 mm),...
-
4.34.6.5(1)
(1) The sink and surrounding counter shall be mounted at a maximum height of 34 in (865 mm) above the floor, measured from the floor to the top of the counter surface, or shall be adjustable...
-
Handrails [§504.6, §505]
Stairway Handrails Recommendation: In facilities that primarily serve children, a second set of stairway handrails 28” high maximum above stair nosings is advisable....
-
1134A.8, Item 1
The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor....
-
11B-812.7.2 Marking
The area within the borderlines shall be marked with hatched lines a maximum of 36 inches (914 mm) on center....