It is recommended that, where possible, providing one component or element of a component at a lower height, or multiple overhead components at varied heights, would better accommodate more...
Search Results "Non-Fixed Element"
Filters
Commonly Searched Documents
-
7. Should overhead play components such as track riders, ring ladders, monkey bars, and chin up bars be lowered to the recommended reach ranges?
-
707.1 General
Place accessible gates and fare vending machines in close proximity to other accessible elements when feasible so the facility is easier to use....
-
Gripping Surface Cross Section and Clearances M301, M302, and M305.2
Gripping Surface Cross Section and Clearances M301, M302, and M305.2 Gripping surface for transfer supports shall be free of sharp or abrasive elements and shall have rounded edges per...
-
707.1 General
Place accessible gates and fare vending machines in close proximity to other accessible elements when feasible so the facility is easier to use....
-
106.5.68 Technically Infeasible
removing or altering a load-bearing member that is an essential part of the structural frame; or because other existing physical or site constraints prohibit modification or addition of elements...
-
Alteration
Alterations include, but are not limited to, remodeling, renovation, rehabilitation, reconstruction, historic restoration, changes or rearrangement of the structural parts or elements, and...
-
Audible Alarms [4.28.2]
Recommendation: Alarms with a periodic element to the signal, such as single stroke bells, hi-low, and fast whoop, are considered more effective than those with continuous or reverberating...
-
Width [4.3.3.] and Passing Space [4.3.4]
However, the minimum width of hallways and corridors is often further determined by ADAAG requirements for clear floor space at elements such as drinking fountains, door maneuvering clearances...
-
Alteration of a recreation site, building, or facility
remodeling, renovation, rehabilitation, reconstruction, historic restoration, change in surface of circulation paths or vehicular ways, changes or rearrangement of the structural parts or elements...
-
TEMPORARY
Temporary as applied to elements means installed for less than 6 months and not required for safety reasons....
-
1.1.9 Horizontal gaps and vertical alignment
Measure for local horizontal discontinuities and variations in vertical alignment such as at concrete joints, gaps, grade breaks, and at the interface of concrete with other materials or elements...
-
4 - Best practices for construction observation
4 - Best practices for construction observation Construction observation is the final step in building an accessible element to meet design and regulatory requirements....
-
Surface and Size [§305.2 and §305.3]
Additional space is required when the space is confined on three sides and is obstructed for more than half the depth, such as when elements are recessed in alcoves....
-
Alterations and Additions
Users of this guide must familiarize themselves with the specific scoping requirements that apply to each element, building, facility, or site that is subject to the Standards adopted to...
-
ACCESSIBLE ROUTE
[DSA-AC & HCD 1-AC] A continuous unobstructed path connecting accessible elements and spaces of an accessible site, building or facility that can be negotiated by a person with a disability...
-
11B-403.5.2 Clear width at turn
Where the accessible route makes a 180 degree turn around an element which is less than 48 inches (1219 mm) wide, clear width shall be 42 inches (1067 mm) minimum approaching the turn, 48...
-
1.1.7.3.1 Detached one- and two-family dwellings
egress, and their accessory structures, may be designed and constructed in accordance with this code or the California Residential Code, but not both, unless the proposed structure(s) or element...
-
11B-403.5.2 Clear width at turn
Where the accessible route makes a 180 degree turn around an element which is less than 48 inches (1219 mm) wide, clear width shall be 42 inches (1067 mm) minimum approaching the turn, 48...
-
ACCESSIBLE ROUTE
[DSA-AC & HCD 1-AC] A continuous unobstructed path connecting accessible elements and spaces of an accessible site, building or facility that can be negotiated by a person with a disability...
-
3. How can state and local governments’ employment service systems ensure that people with disabilities have access to competitive integrated employment?
Access to Integration During Non-Work Hours In addition to integrated supported employment services on the job, integration in non-work services also supports the achievement of competitive...
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
Grab bars with non-circular cross sections must have a cross section dimension of 2 inches maximum and a perimeter dimension of 4 inches minimum and 4.8 inches maximum....
-
Qualitative and Observational Analysis by Surface Type
in comparison to the larger fines may contribute to more washout or erosion, whereas not enough smaller fines may lead to lots of loose, larger aggregate pieces that can contribute to a non-firm...
-
Meeting User Needs
In fact, this alternative added sufficient flexibility to accommodate independent and assisted transfers that it also was used in non age-segregated healthcare facilities, such as Beechwood...
-
What Are Testing Accommodations?
. §§ 36.303(b), 36.309(b)(3) (providing non-exhaustive lists of auxiliary aids and services). ...