2010 ADA Standards for Accessible Design (available on ADA.gov and from the ADA Information Line) Sections 208 & 502 Parking Spaces Section 206 Accessible Route Duplication...
Search Results "ADA Compliance"
-
Reference
-
11B-407.2.2.4 Reserved
ETA Editor's Note Lacking certain Exceptions allowed by 2010 ADA Standards, and imposing additional requirements regarding visible signals, the preceding CBC requirements pertaining...
-
11B-216.11 Check-out aisles
[2010 ADA Standards] 216.11 Check-Out Aisles....
-
11B-904.4.1 Parallel approach
[2010 ADA Standards] 904.4.1 Parallel Approach....
-
11B-604.4 Seats
[2010 ADA Standards] 604.4 Seats....
-
11B-216.11 Check-out aisles
[2010 ADA Standards] 216.11 Check-Out Aisles....
-
11B-604.4 Seats
[2010 ADA Standards] 604.4 Seats....
-
11B-502.5 Vertical clearance
[2010 ADA Standards] 502.5 Vertical Clearance....
-
11B-904.4.1 Parallel approach
[2010 ADA Standards] 904.4.1 Parallel Approach....
-
11B-502.5 Vertical clearance
[2010 ADA Standards] 502.5 Vertical Clearance....
-
Sec.36.304(d)(2)
(2) If, as a result of compliance with the alterations requirements specified in paragraph (d)(1) of this section, the measures required to remove a barrier would not be readily achievable...
-
403.5.2 Clear Width at Turn
EXCEPTION: Where the clear width at the turn is 60 inches (1525 mm) minimum compliance with 403.5.2 shall not be required. Figure 403.5.2 Clear Width at Turn...
-
Exceptions [1014.1, Exceptions 1 and 2]
When a condition for exception does not permit full compliance with a specific provision in the technical requirements for camp shelters, the camp shelter must comply with the specific provision...
-
12185(e) Review
the study required by subsection (a) of this section, the Office of Technology Assessment shall provide a preliminary draft of such study to the Architectural and Transportation Barriers Compliance...
-
412.1 General (Section-by-Section Analysis)
Would compliance with section 412 be readily achievable for manufacturers of mobile telecommunications equipment?...
-
4.1.7(1)(a) General Rule
applicable technical specifications of 4.2 through 4.35 and the applicable special application sections 5 through 10 unless it is determined in accordance with the procedures in 4.1.7(2) that compliance...
-
10.2.1(3)
Signs that are sized to the maximum dimensions permitted under legitimate local, state or federal regulations or ordinances shall be considered in compliance with 4.30.2 and 4.30.3 for purposes...
-
LARGE AREA ASSISTIVE LISTENING SYSTEMS (ALS): REVIEW AND RECOMMENDATIONS
Large Area Assistive Listening Systems: Review and Recommendations Final Report to United States Architectural and Transportation Barriers Compliance Board (U.S....
-
3.4.1 General
When a new viewing area is constructed, or an existing viewing area is altered or reconstructed, if a condition for exception in section 1.1 prohibits full compliance with a specific requirement...
-
§100.75(d)
(d) 24 CFR part 109 provides information to assist persons to advertise dwellings in a nondiscriminatory manner and describes the matters the Department will review in evaluating compliance...
-
III-9.4000 Preliminary determination
If the Assistant Attorney General's office decides to proceed, the office will consult with the Architectural and Transportation Barriers Compliance Board....
-
2.3.1
2.3.1 Define the measurement protocols to be used to check for compliance with the tolerances and standards....
-
Small entities potentially affected by proposed standards
discussed below, if an enforcing authority such as DOJ adopts the standards as mandatory requirements for entities subject to its jurisdiction, small health care providers may experience some compliance...
-
§ 37.5(i)(1) Private entity-private transport
This obligation includes, with respect to the provision of transportation services, compliance with the requirements of the rules of the Department of Justice concerning eligibility criteria...