If a soil stabilizer was not used, please indicate the application method and material(s) used to achieve the natural surface....
Search Results "Side Transfer Surface"
-
18. If a soil stabilizer was not used, please indicate the application method and material(s) used to achieve the natural surface
-
1132A.4 Level floor or landing
The floor or landing on each side of a door shall be level....
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
Subjects
There are two columns; the left side lists the disability and the right side gives the number of subjects who reported having that disability. ...
-
Water Play Components: ADA Standard Section 1008.2.3
Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with 302, 403.3, 405.2, 405.3, and 1008.2.6...
-
904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
A6
If a curb ramp is provided, is the running slope of the ramp surface (not counting the side flares) no more than 1:12 or 8.33% [ADA Standards § 4.7.2] Yes No...
-
M305.3 Standing Supports (Section-by-Section Analysis)
and whether standing supports can provide a 1½ inch minimum clearance around the gripping surface....
-
7(2)(b)(iv)
(iv) Toilets are located within bathrooms in a manner that permit a grab bar to be installed on one side of the fixture....
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
The need to reach heights above 32 inches interferes with efforts to lower the transfer surface height....
-
19. Please indicate the duration of the warranty/guarantees offered for the surface product used by the sales representative/vendor
Please indicate the duration of the warranty/guarantees offered for the surface product used by the sales representative/vendor....
-
Handrails
Handrails are required along both sides of ramps and stairs....
-
Outdoor Constructed Features
Outdoor constructed features can be confined on all or part of three sides by surfaces that are not firm and stable or that have changes in level....
-
Bedside Clearances
Bedside Clearances Clearance at least 36 inches wide is required on each side of beds. Where more than one bed is provided, this space can overlap....
-
11B-610.3 Shower compartment seats
A seat in a standard roll-in shower compartment shall be a folding type, shall be installed on the side wall adjacent to the controls, and shall extend from the back wall to a point within...
- Bobrick B-279 ClassicSeries® Surface-Mounted Waste Receptacle
- Bobrick TrimLineSeries ADA Surface-Mounted Hand Dryer B-7128.115V
- Norton Surface Mounted 7100SZ Series SafeZone® Electromechanical Closer
-
Camp Shelters
Ensure that the surface of the clear floor or ground space at the open entrance side of the shelter and the floor of the shelter is firm, stable, and does not slope more than 2 percent (...
-
10 [§ 4.7.5]
10 [§ 4.7.5] Answer this question only if you skipped the previous two questions because the curb ramp you are surveying does not have flared sides....
-
A4.17.5 Doors
To make it easier for wheelchair users to close toilet stall doors, doors can be provided with closers, spring hinges, or a pull bar mounted on the inside surface of the door near the hinge...
-
A4.17.5 DOORS
To make it easier for wheelchair users to close toilet stall doors, doors can be provided with closers, spring hinges, or a pull bar mounted on the inside surface of the door near the hinge...
-
R309.2 Parallel Parking Spaces
The sidewalk adjacent to accessible parallel parking spaces should be free of signs, street furniture, and other obstructions to permit deployment of a van side-lift or ramp or the vehicle...
- Armor-Tile Tactile Systems Cast In Place Detectable Warning Surface System