Durable, 22-gauge galvanized steel with exposed surface, type 304 satin-finish stainless steel cover having #4 satin-finish vertical grain with black plastic trim, automatic sensor, dual...
Search Results "Side Transfer Surface"
- Bobrick TrimLineSeries ADA Surface-Mounted Hand Dryer B-7128.115V
-
7(2)(b)(iv)
(iv) Toilets are located within bathrooms in a manner that permit a grab bar to be installed on one side of the fixture....
-
Re: American Specialties 9014 Surface Mounted Horizontal Baby Changing Station
Rejected this after installation. The design of the hand hold is completely sloped at about 45 degrees. My fingers slipped off unless I applied tremendous pinching force to operate....
- Norton Surface Mounted 7100SZ Series SafeZone® Electromechanical Closer
-
Subjects
There are two columns; the left side lists the disability and the right side gives the number of subjects who reported having that disability. ...
-
Water Play Components: ADA Standard Section 1008.2.3
Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with 302, 403.3, 405.2, 405.3, and 1008.2.6...
-
M305.3 Standing Supports (Section-by-Section Analysis)
and whether standing supports can provide a 1½ inch minimum clearance around the gripping surface....
-
Handrails
Handrails are required along both sides of ramps and stairs....
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
The need to reach heights above 32 inches interferes with efforts to lower the transfer surface height....
- Armor-Tile Tactile Systems Cast In Place Detectable Warning Surface System
- Bobrick TrimLineSeries ADA Surface-Mounted Hand Dryer B-7128.230V
-
Bedside Clearances
Bedside Clearances Clearance at least 36 inches wide is required on each side of beds. Where more than one bed is provided, this space can overlap....
-
19. Please indicate the duration of the warranty/guarantees offered for the surface product used by the sales representative/vendor
Please indicate the duration of the warranty/guarantees offered for the surface product used by the sales representative/vendor....
- CRL PR40 Series Adjustable Spring Power Surface Mounted Door Closers
-
A4.17.5 Doors
To make it easier for wheelchair users to close toilet stall doors, doors can be provided with closers, spring hinges, or a pull bar mounted on the inside surface of the door near the hinge...
-
A4.17.5 DOORS
To make it easier for wheelchair users to close toilet stall doors, doors can be provided with closers, spring hinges, or a pull bar mounted on the inside surface of the door near the hinge...
-
11B-610.3 Shower compartment seats
A seat in a standard roll-in shower compartment shall be a folding type, shall be installed on the side wall adjacent to the controls, and shall extend from the back wall to a point within...
-
10 [§ 4.7.5]
10 [§ 4.7.5] Answer this question only if you skipped the previous two questions because the curb ramp you are surveying does not have flared sides....
-
Outdoor Constructed Features
Outdoor constructed features can be confined on all or part of three sides by surfaces that are not firm and stable or that have changes in level....
- AJW Architectural Products U593 1.6 Gallon Sanitary Napkin Disposal w/ Mounted Shelf - Surface Mounted
-
R309.2 Parallel Parking Spaces
The sidewalk adjacent to accessible parallel parking spaces should be free of signs, street furniture, and other obstructions to permit deployment of a van side-lift or ramp or the vehicle...
-
Camp Shelters
Ensure that the surface of the clear floor or ground space at the open entrance side of the shelter and the floor of the shelter is firm, stable, and does not slope more than 2 percent (...
-
RECOMMENDATIONS
Second, in the absence of any better information, it is recommended that a number of immediate changes be implemented to ADAAG to better accommodate assisted transfers in facilities used...
- Boost Your Business - Chapter 2 - Parking