crisp, slightline with no linear waviness Profile engineered for improved ease of installation Key Specifications: Architectural Compression Seals Joint width...
Search Results "Ramp Width"
Commonly Searched Documents
- Inpro Corporation JointMaster® AR Series Seal Expansion Joint Systems
-
307.3 Post-Mounted Objects
EXCEPTION: The sloping portions of handrails serving stairs and ramps shall not be required to comply with 307.3. Figure 307.3 Post-Mounted Protruding Objects...
-
R105 Definitions (Section-by-Section Analysis)
The proposed guidelines define the following terms: accessible, alteration, blended transition, cross slope, curb line, curb ramp, element, facility, grade break, operable part, pedestrian...
-
11B-244.1 General
The CBC requires raised areas of the facility to provide access by ramp, special access lift or elevator. ...
-
Access to Performing Areas [4.33.5]
While handrails are not required on ramps adjacent to assembly seating, locating aisles (including those that are stepped) along walls will permit handrails on one side for the benefit of...
-
Dining Areas in Restaurants and Cafeterias
requirement for vertical access, an accessible route within each story or mezzanine is still required to connect dining areas and other spaces and elements even though an elevator (or ramp...
-
THE SETTLEMENT CLASS
from the beginning of time through the thirty-year term of the Settlement Agreement: (1) accessed or attempted to access any sidewalks, intersections, crosswalks, streets, curbs, curb ramps...
-
11B-244.1 General
The CBC requires raised areas of the facility to provide access by ramp, special access lift or elevator. ...
-
11B-244.1 General
The CBC requires raised areas of the facility to provide access by ramp, special access lift or elevator....
-
How can existing buildings be retrofitted to make them accessible?
At such facilities a separate ramp or an alternative entrance may have to be used. This may include adding an elevator or lift inside a two-story building....
-
Mobility
And the changes in surface elevation – ramps on sidewalks – these types of things....
-
1132A.4 Level floor or landing
Changes in height greater than ½ inch (12.7 mm) shall be accomplished by means of a ramp complying with Section 1114A or by means of a platform constructed to the level of the floor as illustrated...
-
F105.2.2 ASME
standard includes additional provisions for runway enclosures, electrical equipment and wiring, structural support, headroom clearance (which is 80 inches minimum), lower level access ramps...
-
Other Contrast Attributes
on the basis that their belief that curb ramps would be dangerous to blind people....
- GE Profile™ Series 30" Slide-In Double Oven Electric Convection Range PS950EFES
- Grainger Soap Dispenser, 800mL, Ceramic White
- Inclusion Solutions Frankie Adjustable Single Voting Booth
-
PART 3: ACCESSIBLE EXAMINATION ROOMS
The features that make this possible are: an accessible route to and through the room; an entry door with adequate clear width, maneuvering clearance, and accessible hardware;...
-
Protruding Objects [1017.9]
Objects that protrude into the trail clear tread width, passing spaces, and resting intervals can pose hazards to people who are blind or have low vision....
-
11B-504.4.1 Contrasting stripe
The stripe shall extend the full width of the step or upper approach and shall be of material that is at least as slip resistant as the other treads of the stair....
-
Scoping [4.1.2(1), 4.1.3(1)] and Location [4.3.2]
Clear width, surface texture, running and cross slope, and the treatment of changes in level help determine the usability of walking surfaces by people with mobility impairments....
-
4.1.2 Number of Wheelchair Seating Spaces
Number of Wheelchair Seating Spaces Table Top Perimeter Typical Table Length (for 2 ft. 6 in. table width) Number of Wheelchair Seating Spaces Required Up...
-
Engineered Surfaces
Table 3: Engineered Surface Identification Surface ID: Roughness Index (in/ft): Crack Frequency (in): Crack Width (in):...
-
Clear Floor Space: Minimum Clear Floor Space Required for Forward and Side Approach - Manual Wheelchair
These dimensions are: (A) occupied width, the horizontal distance between the side-most (lateral-most) points of the wheelchair or occupant on the right and left side; (B) occupied length...