To make it easier for wheelchair users to close toilet stall doors, doors can be provided with closers, spring hinges, or a pull bar mounted on the inside surface of the door near the hinge...
Search Results "Door Opening Angle"
Commonly Searched Documents
-
A4.17.5 Doors
-
A4.17.5 DOORS
To make it easier for wheelchair users to close toilet stall doors, doors can be provided with closers, spring hinges, or a pull bar mounted on the inside surface of the door near the hinge...
-
Doors in a Series
The required separation between doors and gates in series and specifications for maneuvering clearances at doors will ensure sufficient space regardless of the door swing....
- Sargent 1331 Series Aluminum Door Closer
- Stanley Hardware 8179 Light Commercial Door Closer
-
Measuring Door Openings
Special care is needed when measuring the clear opening of a doorway. To measure the clear opening of a standard hinged door, open the door to 90 degrees....
- DORMA BTS80 EMB Series Door Closer
-
Openings in Outdoor Recreation Access Route Surfaces
Openings are gaps in the surface of an outdoor recreation access route. Gaps include spaces between the planks on a boardwalk or in a drainage grate....
- Yale 3000 Series Architectural Door Closer
-
Revolving Doors or Turnstiles
A commenter advised that no revolving doors or turnstiles should be permitted on an accessible route. Response....
-
Sharing an Access Aisle
The Board has included a requirement that where angled spaces are provided, the access aisle must be located on the passenger side of van spaces (502.3.4)....
-
Doors at Entrances to Businesses
However, some older doors are less than 36 inches wide and may not provide enough width (32 inch clear width when fully opened). Door openings can sometimes be enlarged....
- Hager Companies 5200 Series - Heavy Duty Door Closer
-
11B-404.2.8.1 Door closers and gate closers
Door closers and gate closers shall be adjusted so that from an open position of 90 degrees, the time required to move the door to a position of 12 degrees from the latch is 5 seconds minimum...
-
11B-404.2.8.1 Door closers and gate closers
Door closers and gate closers shall be adjusted so that from an open position of 90 degrees, the time required to move the door to a position of 12 degrees from the latch is 5 seconds minimum...
- Cal-Royal 300 Series Hydraulic Door Closers
- Cal-Royal 900 Series Hydraulic Door Closers
-
Doors and Gates in Series [§404.2.6]
Doors and Gates in Series [§404.2.6] At hinged or pivoted doors or gates in series, a separation is required that is at least 48” plus the width of doors or gates swinging into the space...
- Hager Companies 5100 Series - Heavy Duty Surface Door Closer
- Cal-Royal CR441 Series Hydraulic Door Closers
-
12162(a)(2)(B)(i)
(i) be able to be entered by an individual who uses a wheelchair;
- Cal-Royal 700 Series Hydraulic Door Closers
- CRL PR40 Series Adjustable Spring Power Surface Mounted Door Closers
-
11B-604.8.1.2 Doors
Where located in the front partition, the door opening shall be 4 inches (102 mm) maximum from the side wall or partition farthest from the water closet....