Windows requiring pushing, pulling, or lifting to open (for example, double-hung, sliding, or casement and awning units without cranks) should require no more than 5 lbf (22.2 N) to open...
Search Results "End-Opening Door"
Commonly Searched Documents
-
A4.12.2 Window Hardware
- Pilot Rock T-600 Series Caterpillar Picnic Table
-
II. Systemic Considerations
Training criminal justice personnel, conducting reviews of policies and procedures, and collaborating with mental health and disability services providers are three ways to achieve that end...
-
4.30.6 Mounting Location and Height
Where permanent identification is provided for rooms and spaces, signs shall be installed on the wall adjacent to the latch side of the door....
-
13) Detectable warnings
13) Detectable warnings ADAAG: Required on curb ramps, hazardous vehicular areas, and reflecting pools, but not on doors to hazardous areas....
-
11B-104.1.1 Construction and manufacturing tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
11B-104.1.1 Construction and manufacturing tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
Sloped Surfaces
Rest one end of the level at the highest point of the sloped surface and lift the other end (see image) until the bubble is in the middle of the tube. This is the "level" position....
-
Observations:
The wheelchair scale we used had a leveled surface of length 30 in. long with a bevel of 5 in. each at both ends (i.e., total length of 40 in.)....
-
11B-809.10.6.1 Size
unit, as least one shower stall shall comply with one of the following: A transfer type shower compartment 36 inches (914 mm) wide by 36 inches (914 mm) deep with an entrance opening...
-
11B-1004.1 Clear floor space
To optimize space use, designers should carefully consider layout options such as connecting ends of the row and center aisle spaces....
-
11B-227.2 Check-out aisles
When check-out aisles are open for customer use, the business should ensure that a minimum of one accessible check-out aisle is always available for use by persons with disabilities....
-
704.2.3 Combustible projections
Combustible projections located where openings are not permitted or where protection of openings is required shall be of at least 1-hour fire-resistance-rated construction, Type IV construction...
- AJW Architectural Products U6084 Unidoor Folded Towel Dispenser & Waste Receptacle Combination - Recessed
- Pilot Rock BPR1 Bear Resistant Trash Receptacle
-
§ 36.303(g)(6)(ii)
(ii) A public accommodation may use open movie captioning as an alternative to complying with the requirements specified in paragraph (g)(3) of this section, either by providing open movie...
-
704.10 Vertical exposure
For buildings on the same lot, approved protectives shall be provided in every opening that is less than 15 feet (4572 mm) vertically above the roof of an adjoining building or adjacent...
-
Location: ADA Standard Section 407.4.6.1
Section 407.4.6.1 covers the current ADA Standards for the location of elevator car controls.
-
11B-407.4.6.1 Location
Exceptions: Where the elevator panel serves more than 16 openings and a parallel approach is provided, buttons with floor designations shall be permitted to be 54 inches (1372 mm)...
- Door King Inc. 6004 Column Mount Swing Gate Operator
- Door King Inc. VoIP Integration for Entry and Access Control Systems
- Jacknob Corp. 6409 ADA Latch & Strike Combo for Inswinging Door
-
1017.4 Passing Spaces
Where the full length of a trail does not fully comply with 1017, a passing space shall be located at the end of the trail segment that fully complies with 1017....
-
1017.4 Passing Spaces
Where the full length of a trail does not fully comply with 1017, a passing space shall be located at the end of the trail segment that fully complies with 1017....