Are all drapery control wands, fixed lamps and HVAC controls in accessible guestrooms placed within 54" of the floor for side approach or 48" of the floor for forward approach so persons...
Search Results "Hinge Side Clearance"
-
L. Controls
-
4.7.11 Islands
Any raised islands in crossings shall be cut through level with the street or have curb ramps at both sides and a level area at least 48 in (1220 mm) long between the curb ramps in the part...
-
§ 38.113(a)(1)
(1) At least one doorway, on each side of the car from which passengers board, of each car required to be accessible by §38.111(a) and where the spaces required by §38.111(d) of this part...
-
604.9.5 Flush Controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with 604.8.2....
-
608.2.2 Standard Roll-In Type Shower Compartments
Standard roll-in type shower compartments shall be 30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
A4.6.3 Parking Spaces
The increasing use of vans with side-mounted lifts or ramps by persons with disabilities has necessitated some revisions in specifications for parking spaces and adjacent access aisles....
-
Salsbury Industries Designer Wood Locker Single Tier 1 Wide
or 3 wide units 1 wide units come fully assembled while 3 wide units require minor assembly All locker doors are 12" wide x 3/4" deep All locker doors include heavy duty concealed hinges...
-
Salsbury Industries Designer Wood Locker Single Tier 3 Wide
or 3 wide units 1 wide units come fully assembled while 3 wide units require minor assembly All locker doors are 12" wide x 3/4" deep All locker doors include heavy duty concealed hinges...
-
Delta Widespread Lavatory Faucet 3552-MPU-DST
indicators Metal pop-up 3/8" compression fittings 2 1/4" max. deck thickness No thick deck kit available 32" minimum InnoFlex supply lines below the deck included Min. 2 1/2" clearance...
-
Bobrick TrimLineSeries Recessed Paper Towel Dispenser B-35903
Door equipped with full-length stainless steel piano-hinge at bottom; swings down for easy filling. Rough Wall Opening: 11 1⁄4" W, 15 5⁄8" H, 4" min. depth (285 x 395 x 100mm)....
-
11B-904.3.2 Counter
The top of the counter edge protection shall be 2 inches (51 mm) maximum above the top of the counter surface on the aisle side of the check-out counter....
-
T402.7 Edge Guards
Ramps and bridgeplates shall provide edge guards continuously along each side of the ramp or bridgeplate to within 3 inches (75 mm) of the end of the ramp or bridgeplate that is deployed...
-
G. Compartment Size
.: diagonal or side approaches)? [ADA Stds. 4.17.3] Yes __ No __ N/A __ Comments: ___________________________________________...
-
R207.1 General
The curb ramp (excluding any flared sides) or blended transition shall be contained wholly within the width of the pedestrian street crossing served....
-
AJW Architectural Products U730 Series 16.25"W x 22.25"H Medicine Cabinet w/ White Enamel Finish - Recessed
Hinges: Heavy duty piano type hinges....
-
AJW Architectural Products U582 1.5 Gallon Sanitary Napkin Disposal - Surface Mounted
Locks: Pin tumbler commercial quality locks keyed like all other AJW cabinets, Hinge: Full length, heavy duty, stainless steel piano type hinge, Overall Size: 11"W x 15 1/4"H x 4"D...
-
AJW Architectural Products U8504 Unidoor Seat Cover Dispenser - Recessed
Hinge: Full length, stainless steel piano type hinge. Lock: Pin tumbler commercial quality, keyed like all other AJW cabinets....
-
11B-226.1 General
Consider work surfaces that are flexible and permit installation at variable heights and clearances. ◼...
-
Telescopes and Periscopes
Provide knee and toe clearance complying with ABAAS, section 306, under the telescope or periscope (figure 98)....
-
1132A.2 Interior doors and secondary exterior doors
The provisions of this section shall apply to the dwelling unit side of doors leading from the interior of the dwelling unit to an unfinished basement or an attached garage....
-
802.1.3 Depth
Where a wheelchair space can be entered only from the side, the wheelchair space shall be 60 inches (1525 mm) deep minimum....
-
Common Problems with Routes to Building Entrances
Ø Ramps are too steep or go too long without level rest areas; handrails are not provided on both sides....
-
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces
Standing supports should be located on both sides of platforms, a minimum of 34 inches between supports, integrated into the platform, and 32 inches minimum length (at least 80% of the platform...
-
Approach
One side of the wheelchair space must adjoin an accessible route. The turning space may overlap the accessible route and the required clear floor space....
