The fire-resistance-rated exterior wall construction shall extend horizontally 10 feet (3048 mm) beyond the landing on either side of the landing or equivalent fire-resistance-rated construction...
Search Results "Hinge Side Clearance"
-
1009.7.2 Separation
-
11B-604.5.2 Rear wall
The rear wall grab bar shall be 36 inches (914 mm) long minimum and extend from the centerline of the water closet 12 inches (305 mm) minimum on one side and 24 inches (610 mm) minimum on...
-
A4.22.3 Clear Floor Space
It is important to keep in mind that the placement of the lavatory to the immediate side of the water closet will preclude the side approach transfer illustrated in Figure A6(b)....
-
Cassette Recordings (Advisory Guidance)
The cost of a duplicator can be higher depending upon the number of copies produced on a single run, and whether the duplicator can produce standard speed two-sided copies or half-speed...
-
11B-504.8 Floor identification
Chapter 10, Section 1023.9 complying with Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5 shall be located at the landing of each floor level, placed adjacent to the door on the latch side...
-
Re: Lavatories Adjacent to Partitions
11B-606.6 Adjacent side wall or partition. Lavatories, when located adjacent to a side wall or partition, shall be a minimum of 18 inches (457 mm) to the centerline of the fixture....
-
AJW Architectural Products U230 Series C-fold/Multifold Towel Dispenser - Recessed
gauge stainless steel with a #4 satin finish Holds 600 c-fold or 800 multifold towels Secured with pin tumbler lock, keyed like all AJW cabinets Made with heavy duty piano type hinges...
-
AJW Architectural Products U683 Dual Stall Toilet Tissue Dispenser & Sanitary Napkin Disposal - Partition Mounted
Hinges: All hinges are full length, heavy duty, stainless steel piano type hinges....
-
AJW Architectural Products U684 Series Dual Toilet Tissue Dispenser & Sanitary Napkin Disposal - Recessed
Hinges: All hinges are full length, heavy duty, stainless steel piano type hinges. Collars: #22 ga stainless steel finished to match cabinet....
-
Greenfields Outdoor Fitness Two-Person Accessible Combo Butterfly and Reverse Fly GR2005-1-48E-W (2 Configurations)
Reverse Fly GR2005-1-48E-W Target muscle - secondary muscles Strengthens chest, shoulders, back, arms, and upper and mid-abs Configuration A Accessible side...
-
5.1.6 Clear Floor or Ground Space
One full unobstructed side of the clear ground space shall adjoin or overlap the trail or ORAR, as applicable, or another clear ground space. ...
-
4.8.5* Handrails
If a ramp run has a rise greater than 6 in (150 mm) or a horizontal projection greater than 72 in (1830 mm), then it shall have handrails on both sides....
-
11B-610.3.1 Rectangular seats
The side edge of the seat shall be 1½ inches (38 mm) maximum from the adjacent wall....
-
Telescopes and Periscopes
Provide knee and toe clearance complying with ABAAS, section 306, under the telescope or periscope (figure 98)....
-
A4.6.3 Parking Spaces
The increasing use of vans with side-mounted lifts or ramps by persons with disabilities has necessitated some revisions in specifications for parking spaces and adjacent access aisles....
-
Magnuson Group 2000 Series Magazine Racks
Available with one, two, three or four pocket configurations, these racks can be installed with or without wood side panels....
-
Bobrick Surface-Mounted Medicine Cabinet B-297
Door has enameled steel piano-hinge and magnetic catch. Door is 14 1⁄8" W, 20 1⁄4" H (360 x 515mm). Unit 3 3⁄4" (95mm) deep....
-
Protruding Objects
One element of a barrier-free meeting space for participants who are blind or have low vision requires cane-detectable protruding objects and sufficient head clearance....
-
Adaptability
Rooms need to be designed to provide required clear floor space at fixtures, turning space, and door clearance....
-
Counters and Bars [5.2]
Types of Counters Maximum Height Minimum Length Knee Clearance (forward approach) Dining/Bars (service) 34 in 60 in required Dining/Bars...
-
M101.3 Equivalent Facilitation
However, the standards include technical criteria for clearance in or around the base of the equipment for lift compatibility to allow the use of a patient lift by patients with disabilities...
-
904.3.2 Counter
The top of the counter edge protection shall be 2 inches (51 mm) maximum above the top of the counter surface on the aisle side of the check-out counter....
-
604.9.5 Flush Controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with 604.8.2....
-
604.9.5 Flush Controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with 604.8.2....
