In the proposed rule, the Board sought to clarify the requirement in the original ADAAG that accessible urinals have an "elongated" rim by specifying a minimum dimension of 13 ½ inches, measured...
Search Results "Unit of Measurement"
Filters
Commonly Searched Documents
-
Urinal Depth
-
502.6 Identification
Signs shall be 60 inches (1525 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [ECTCR UFAS 4.6.4] Advisory 502.6 Identification....
-
Cross Slope
Once placed in the water, measurements, absent live loads, are to be made from a static condition (i.e., absence of movement that results from wind, waves, etc.)....
-
R302.6 Cross Slope
The cross slope of the pedestrian access route is measured perpendicular to the direction of pedestrian travel....
-
306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
Side Reach [4.2.6]
High and low reaches are based on a depth of reach no greater than 10 inches measured from the available clear floor space....
-
Surface Textures [4.3.6]
Since there are no uniform test procedure or measurable values for these characteristics (except for slip-resistance), acceptable and unacceptable materials are not easy to categorize....
-
Size and Clearances [4.21.2]
The 36 by 36 inch dimension, measured to the interior finish, keeps front and side grab bars within reach from the seat....
-
3 - Best practices for pre - construction meetings
Unusual or particularly tight tolerances can be discussed, questions asked, construction techniques suggested, measurement methods outlined, and how compliance will be checked can all be...
-
11B-604.9.6 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 _|Operation|_ and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the...
-
11B-306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
11B-306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
§1607.6 Use of selection procedures which have not been validated.
unscored selection procedure which has an adverse impact is utilized, the user should eliminate the adverse impact, or modify the procedure to one which is a formal, scored or quantified measure...
-
382.23 May carriers require a passenger with a disability to provide a medical certificate?
Under paragraph 382.21(c), if the section 382.23(c)(2) medical certificate provides measures for preventing the transmission of a disease, the carrier must provide transportation to the...
-
b. Exception for Base Support Allowance and Unobstructed Knee and Toe Space
The footrest height data measures the height from the floor to the top surface of the footrest at its proximal outside corner....
-
6. PROJECT COST DETERMINATION:
the project may require DSA review and approval. 1 For purposes of this provision, air conditioning (AC) equipment includes heating, ventilation, and air conditioning (HVAC), AC units...
-
BACKGROUND
The parties (“Parties”) to this Settlement Agreement (“Agreement”) are the United States of America (“United States”) and Franciscan St. James Health (“St....
-
III-4.6100 Examinations
, rather than reflecting the individual's impaired sensory, manual, or speaking skills (except where those skills are the factors that the examination purports to measure)....
-
§382.3 Air transportation
Generally this refers to transportation by aircraft within, to or from the United States....
-
2.5
2.5 In any third party litigation involving Cinemark's stadium-style movie theaters, the United States shall not advocate a position that contradicts or calls into question the terms...
-
602.5 Spout Location
The spout shall be located 15 inches (380 mm) minimum from the vertical support and 5 inches (125 mm) maximum from the front edge of the unit, including bumpers....
-
§ 382.3 Air Transportation
Generally this refers to transportation by aircraft within, to or from the United States. * * * * *...
-
E.6.iv. - Do vendor web sites advertising EIT products or providing information about EIT products to the federal government have to meet the Section 508 standards?
Section 508 applies to Federal departments or agencies, including the United States Postal Service....
-
4.1.3(12)(b)
(b) Shelves or display units allowing self-service by customers in mercantile occupancies shall be located on an accessible route complying with 4.3....