Assistant Attorney General means the Assistant Attorney General, Civil Rights Division, United States Department of Justice....
Search Results "Unit of Measurement"
-
Assistant Attorney General
-
4.15.4 Controls
Unit controls shall be front mounted or side mounted near the front edge....
-
4.15.4 CONTROLS
Unit controls shall be front mounted or side mounted near the front edge....
-
13.5 Brand Hotel
13.5 “Brand Hotel” means a hotel in the United States operating under any of the Brands, including Franchised Hotels....
-
1130A.2 Width
The accessible route into and throughout covered multifamily dwelling units shall be at least 36 inches (914 mm) wide....
-
Assistant Attorney General
Assistant Attorney General means the Assistant Attorney General, Civil Rights Division, United States Department of Justice....
-
1130A.2 Width
The accessible route into and throughout covered multifamily dwelling units shall be at least 36 inches (914 mm) wide....
-
G.
Later, the United States Court of Appeals for the Fifth Circuit so held in Lara v. Cinemark USA, Inc., 207 F.3rd 783 (5th Cir.), cert. denied, 531 U.S. 944 (2000)....
-
Water Flow Height
comment noted that the rationale for this specification is not needed in the text of the requirement and might be misinterpreted as allowing cup dispensers as an alternative to accessible units...
-
§8.57(d) Notice to State or local government
Whenever the Secretary determines that a State or unit of general local government which is a recipient of Federal financial assistance under title I of the Housing and Community Development...
-
END OF DOCUMENT
ANDERSON United States Attorney Date: February 25, 2019 /s/Ellen London ELLEN LONDON ERIC S....
-
1010.1.5 Floor elevation
Landings shall be level except for exterior landings, which are permitted to have a slope not to exceed 0.25 unit vertical in 12 units horizontal (2-percent slope)....
-
Evaluating Physical and Mental Qualification Standards Under the ADA
Standards that measure a physical or mental ability needed to perform a job....
-
11B-804.2 Clearance
Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware....
-
604.9.6 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
404.2.4.3 Recessed Doors and Gates
clearances for forward approach shall be provided when any obstruction within 18 inches (455 mm) of the latch side of a doorway projects more than 8 inches (205 mm) beyond the face of the door, measured...
-
§ 36.303(c)(1)(ii)
should consult with individuals with disabilities whenever possible to determine what type of auxiliary aid is needed to ensure effective communication, but the ultimate decision as to what measures...
-
1134A.6, Item 1.2
1.2 The shower stall shall measure at least 30 inches deep by 60 inches wide (762 mm by 1524 mm) with an entrance opening of at least 60 inches (1524 mm)....
-
4.13.5 Clear Width
Doorways shall have a minimum clear opening of 32 in (815 mm) with the door open 90 degrees, measured between the face of the door and the opposite stop (see Fig. 24(a), (b), (c), and (d...
-
E102.8 Telecommunications Industry Association (TIA)
TIA 1083 defines measurement procedures and performance requirements for the handset generated audio band magnetic noise of wire line telephones, including digital cordless telephones....
-
III-9.8000 Certification and barrier removal in existing facilities
The Department will measure equivalency against subpart D of the title III rule, New Construction and Alterations....
-
Can handrails or other elements overlap door maneuvering clearances?
The door maneuvering clearance must be measured from the leading edge of such elements so that the full clearance is free of any obstruction....
-
4 - Best practices for construction observation
Even though the final responsibility rests with the contractor, the architect, or other design professional should be observing construction and requiring the contractor to use the measurement...
-
Can handrails overlap door maneuvering clearances?
The door maneuvering clearance must be measured from the leading edge of such elements so that the full clearance is free of any obstruction....