The visible signal elements shall be 2 1/2 inches (64 mm) minimum measured along the vertical centerline of the element....
Search Results "Unit of Measurement"
Commonly Searched Documents
-
407.2.2.2 Visible Signals
-
502.6 Identification
Signs shall be 60 inches (1525 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. Advisory 502.6 Identification....
-
B. Analysis
Where potential discrimination has been found, entities have taken necessary corrective measures, such as revising policies and procedures; refining quality assurance processes; and implementing...
-
604.9.6 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
406.8 Detectable Warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured...
-
11B-604.9.6 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 _|Operation|_ and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the...
-
A4.13.11 Door Opening Force
Forces for pushing or pulling doors open are measured with a push-pull scale under the following conditions:...
-
A4.13.11 DOOR OPENING FORCE
Forces for pushing or pulling doors open are measured with a push-pull scale under the following conditions:...
-
R304.2.3 Flared Sides
Where a pedestrian circulation path crosses the curb ramp, flared sides shall be sloped 10 percent maximum, measured parallel to the curb line. Advisory R304.2.3 Flared Sides....
-
306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
306.1 General
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support for an element....
-
4.13.5 CLEAR WIDTH
Doorways shall have a minimum clear opening of 32 in (815 mm) with the door open 90 degrees, measured between the face of the door and the stop (see Fig. 24(a), (b), (c), and (d))....
-
§ 38.159(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, measured on level ground, for a maximum rise of 3 inches (75 mm), and the transition from roadway...
-
11B-604.9.6 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
-
11B-608.8 Shower enclosures
Enclosures for shower compartments shall not obstruct controls, faucets, and shower spray units or obstruct transfer from wheelchairs onto shower seats....
-
608.8 Shower Enclosures
Enclosures for shower compartments shall not obstruct controls, faucets, and shower spray units or obstruct transfer from wheelchairs onto shower seats....
-
1130A.2 Width
The accessible route into and throughout covered multifamily dwelling units shall be at least 36 inches (914 mm) wide....
-
9.2.2(3)
(3) Doors and doorways designed to allow passage into and within all sleeping rooms, suites or other covered units shall comply with 4.13....
-
§100.305(e)(4)
(4) There are units occupied by persons who are necessary to provide a reasonable accommodation to disabled residents as required by §100.204 and who are under the age of 55....
-
AGREED RESOLUTION
The parties agree that it is in their best interests, and the United States believes that it is in the public interest, to voluntarily enter into this Agreement....
-
11B-608.8 Shower enclosures
Enclosures for shower compartments shall not obstruct controls, faucets, and shower spray units or obstruct transfer from wheelchairs onto shower seats....
-
Installation of Test Surfaces
Measure the needed material by volume (1.5x the volume needed). b) Measure EWF moisture content. c) Measure the binder as a proportion of EWF dry weight....
-
Digital Human Models
Although the true center of rotation remains unknown for most joints, especially for the more complex joints such as the hip and shoulder, anthropologists measure the length of various links...
-
Section 36.304 Removal of Barriers (Preamble, Section-by-Section Analysis)
Moreover, the inclusion of a measure on this list does not mean that it is readily achievable in all cases....