Grab bars shall be provided on the back wall and the side wall opposite the seat. Grab bars shall not be provided above the seat....
Search Results "Latch Side Clearance"
-
11B-608.3.2 Standard roll-in type shower compartments
-
603 Toilet and Bathing Rooms
Doors are not permitted to swing into clear floor space or clearance required for any fixture except under certain conditions (603.2.3)....
-
4.31.2 CLEAR FLOOR OR GROUND SPACE
Figure 44 Mounting Heights and Clearances for Telephones...
-
TownSteel TS8000 Grade 2 Fire Rim Device
Length 36" for 30" to 36" wide openings 48" for 36" to 48" wide openings Stile Width Requirement 4-1/2" wide minimum Handing Non-handed Strike 5/8" stop, plus shim for 1/2" stop Latch...
-
Yale 5800 Series Cast Iron Door Closer
The 5800 series features rugged construction, adjustments for backcheck, closing and latch speed, rack and pinion operation and a variety of arm options....
-
Norton Surface Mounted Light Duty 210 Series Door Closer
The 210 features an adjustable spring, tri-packed, nonhold open arms and independent and separate latch, sweep and backcheck intensity valves....
-
Problem Two (Entrance)
Solution: Short ramps or wedges may be used on both sides of the threshold to allow a voter in a wheelchair to pass over the threshold....
-
f-v
Are the controls and operating mechanisms mounted no more than 54 inches above the floor for a side reach or 48 inches for a forward reach?...
-
M21
If a coat hook is provided, is it mounted no higher than 54 inches above the floor for a side approach or 48 inches above the floor for a front approach?...
-
1133A.4.1, Item 3
The sides of adjacent cabinets and the back wall, which may become exposed to moisture or food handling when a countertop is lowered, shall be constructed of durable, nonabsorbent materials...
-
11B-409.4.6.2 Location
Control panels shall be on a side wall, 12 inches (305 mm) minimum from any adjacent wall. FIGURE 11B-409.4.6.2 LOCATION OF PRIVATE RESIDENCE ELEVATOR CONTROL PANEL...
-
1133A.4.1, Item 3
The sides of adjacent cabinets and the back wall, which may become exposed to moisture or food handling when a countertop is lowered, shall be constructed of durable, nonabsorbent materials...
-
Portable Units [4.1.2(6)]
Where ramps are provided, it is important that required door clearances are available at the required level landing....
-
§382.81(d)
(d) For a passenger with a fused or immobilized leg, you must provide a bulkhead seat or other seat that provides greater legroom than other seats, on the side of an aisle that better accommodates...
-
e-iv
Are the highest floor control buttons mounted no more than 54 inches above the floor for a side reach or 48 inches for forward reach? [ADA Standards § 4.10.12 (3)] Yes No...
-
409.4.6.2 Location
Control panels shall be on a side wall, 12 inches (305 mm) minimum from any adjacent wall. Figure 409.4.6.2 Location of Private Residence Elevator Control Panel...
-
4.5.2 Clear Floor or Ground Space
The space shall be positioned for either forward or side approach to the container opening and be adjacent to or overlap the ORAR....
-
M302.3.2 Armrests
Armrests on transfer sides are not permitted to obstruct access to the transfer surface. See M302.2.3 Exception....
-
Bobrick ClassicSeries Surface-Mounted Paper Towel Dispenser B-2620
Door has knob-latch and piano-hinge. Hemmed towel tray opening. Unit 10 3/4" W, 14" H, 4" D (275 x 355 x 100mm)....
-
Bobrick ClassicSeries Surface-Mounted Paper Towel Dispenser B-2621
Door has knob-latch. Hemmed towel tray opening. Unit 10 3/4" W, 7 1/8" H, 4" D (275 x 180 x 100mm)....
-
11B-608.3.2 Standard roll-in type shower compartments
Grab bars shall be provided on the back wall and the side wall opposite the seat. Grab bars shall not be provided above the seat. ...
-
M304.2.2 Standing Supports (Section-by-Section Analysis)
The MDE NPRM proposed requiring standing supports on each side of the standing surface of diagnostic equipment used by patients in the standing position, and compliance with the technical...
