Business and Conference Facilities You will find that the techniques described above to assist guests who are blind or who have low vision in moving throughout your hotel will also help...
Search Results "Measuring Technique"
Filters
Commonly Searched Documents
-
Business and Conference Facilities
-
Knee Clearance: Clearance as Measured from Anterior-Most Abdomen Point - Manual Wheelchair
This depicts knee and toe clearance required by manual chair users for forward approach to elements in the built environment (e.g., dining tables). It references dimensions of...
-
B. Technical standards for criterion-related validity studies
In view of the possibility of bias in subjective evaluations, supervisory rating techniques and instructions to raters should be carefully developed....
-
Portable tactile maps
Portable tactile maps A variety of techniques have been used to produce portable tactile maps....
-
§1607.14 Technical standards for validity studies.
Nothing in these guidelines is intended to preclude the development and use of other professionally acceptable techniques with respect to validation of selection procedures....
-
Dimensions: ADA Standard Section 810.2.2
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
Size: ADA Standard Section 604.3.1
Section 604.3.1 covers the current ADA Standards for the size of the water closet clearance.
-
§ 1194.23(j)
Technologies which use encoding, signal compression, format transformation, or similar techniques shall not remove information needed for access or shall restore it upon delivery....
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
§382.81(a)
You must ensure that your personnel are trained in the location and proper use of movable aisle armrests, including appropriate transfer techniques....
-
Enlarged areas of the map
Their use is common with maps in a visual context but it was an unfamiliar technique for a number of participants. They did not understand why there were two Kitty Hawks on the map....
-
Executive Summary
To develop a standard for surface roughness, a literature review on previous studies related to wheelchair vibrations as well as roughness measurement and analysis techniques was completed...
-
Cross Slope: ADA Standard Section 405.3
Section 405.3 covers the current ADA Standards for cross slope requirements on ramps.
-
Use of Force
use-of-force training curriculum and policy to emphasize conducting threat assessments, determining whether behaviors are disability-related, using CIT whenever feasible, and using de-escalation techniques...
-
Gift Shops
Gift Shops Follow the techniques described above to help guests who are blind or who have low vision shop in your stores....
-
Height: ADA Standard Section 407.2.1.1
Section 407.2.1.1 covers the current ADA Standards for the height of the elevator call controls.
-
11B-604.3.1 Size
Clearance around a water closet shall be 60 inches (1524 mm) minimum measured perpendicular from the side wall and 56 inches (1422 mm) minimum measured perpendicular from the rear wall....
-
11B-233.3.1.2.6.2 Test number one, individual building test
The slopes of the undisturbed site measured in a straight line between the planned entrance and all vehicular or pedestrian arrival points within 50 feet (15,240 mm) of the planned entrance...
-
11B-407.2.1.1 Height
Call buttons and keypads shall be located within one of the reach ranges specified in Section 11B-308, measured to the centerline of the highest operable part. Exception: Reserved....
-
Video Description (Advisory Guidance)
The latter is the technique used for videotapes....
-
11B-608.2.1 Transfer type shower compartments
Transfer type shower compartments shall be 36 inches (914 mm) by 36 inches (914 mm) clear inside dimensions measured at the center points of opposing sides and shall have a 36 inch (914...
-
Size: ADA Standard Section 604.8.1.1
Section 604.8.1.1 covers the current ADA Standards for the size of wheelchair accessible compartments.