The transfer surface must be located so the 28-inch long dimension is parallel to the patient scanning/imaging side of the table....
Search Results "Maximum Dimension"
-
5.2.1.4 Transfer Surface Size Recommendations for Imaging Equipment (M301)
-
Capabilities, Resources, and Facilities
hands-on experience with the measurement of all classes of anthropometric dimensions. hands-on experience with experimental subjects and human use considerations....
-
4.3.5.2 180-degree turn
Accommodation of additional scooter users would increase this dimension by 18 mm (7 in.) (Figure 4‒5)....
-
2 - Specifications
The four items that should be communicated as stated in the introduction to this guide can clearly be defined in the specifications with corresponding dimensions shown on the drawings....
-
References
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical. 303.3 Beveled....
-
Guiding Principles
important for the development of effective mental images Ideally a visitor should be able to explore an entire tactile piece while standing in one spot, which gives an overall dimension...
-
INTRODUCTION
trails and other facilities for nonmotorized transportation users.(2)As its title implies, the guide is written with bicyclists in mind, so its recommendations are based on the physical dimensions...
-
11B-307.4 Vertical clearance
The leading edge of such guardrail or barrier shall be located 27 inches (686 mm) maximum above the finish floor or ground....
-
1007.3.2 Golf Club Reach Range Area
All areas within holes where golf balls rest shall be within 36 inches (915 mm) maximum of a clear floor or ground space 36 inches (915 mm) wide minimum and 48 inches (1220 mm) long minimum...
-
Companion Seats
., in water rides where the rider’s center of gravity is critical) operators must comply with this provision to the maximum extent feasible....
-
1009.4.5 Grab Bars
The top of the gripping surface shall be 4 inches (100 mm) minimum and 6 inches (150 mm) maximum above transfer walls....
-
1004.2.1 Exit or exit access doorways required
TABLE 1004.2.1 SPACES WITH ONE MEANS OF EGRESS OCCUPANCY MAXIMUM OCCUPANT LOAD A,B,E,F,M,U 50 H-1,H-2,H-3 3 H-4,H-5,...
-
§ 36.101(b) Broad coverage
Amendments Act's purpose of reinstating a broad scope of protection under the ADA, the definition of “disability” in this part shall be construed broadly in favor of expansive coverage to the maximum...
-
11B-502.6.4.2
The centerline of the International Symbol of Accessibility shall be a maximum of 6 inches (152 mm) from the centerline of the parking space, its sides parallel to the length of the parking...
-
608.5.2 Standard Roll-In Type Shower Compartments
Where a seat is provided, the controls, faucets, and shower spray unit shall be installed on the back wall adjacent to the seat wall and shall be located 27 inches (685 mm) maximum from...
-
9.2.2(7) Kitchens, Kitchenettes, or Wet Bars
Counter tops and sinks shall be mounted at a maximum height of 34 in (865 mm) above the floor....
-
4.10.14* EMERGENCY COMMUNICATIONS
The highest operable part of a two-way communication system shall be a maximum of 48 in (1220 mm) from the floor of the car....
-
Unified Facilities Guide Specifications
of surface irregularity is to be determined by placing the straightedge on the pavement surface and allowing it to rest on the two highest spots covered by its length and measuring the maximum...
-
§ 35.101(b) Broad coverage
Amendments Act's purpose of reinstating a broad scope of protection under the ADA, the definition of “disability” in this part shall be construed broadly in favor of expansive coverage to the maximum...
-
[F] 907.4.2.2 Height
The maximum effort to activate controls shall be no greater than 5 pounds-force.◼...
-
11B-307.4 Vertical clearance
The leading edge of such guardrail or barrier shall be located 27 inches (686 mm) maximum above the finish floor or ground....
-
11B-705.1.2.3 Islands or cut-through medians
warnings at pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches (51 mm) maximum...
-
11B-303.3 Beveled
Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (12.7 mm) high maximum shall be beveled with a slope not steeper than 1:2. Advisory 11B-303.3 Beveled....
-
11B-812.7.2 Marking
The area within the borderlines shall be marked with hatched lines a maximum of 36 inches (914 mm) on center....