In kitchens within multi-bedroom housing units and on floors containing accessible sleeping rooms with adaptable features in undergraduate student housing, turning spaces complying with...
Search Results "Floor Designation"
Commonly Searched Documents
-
11B-804.2.3 Turning space
- Trench Drain SSB 5038TR .75 Base
-
Minimum Number: ADA Standard Section 234.3
Section 234.3 covers scoping requirements in the current ADA Standards for the minimum number of wheelchair spaces required at amusement rides.
-
Curb or Barrier: ADA Standard Section 405.9.2
Section 405.9.2 covers the current ADA Standards for a curb or barrier that is provided as edge protection at a ramp.
-
11B-407.4.7.1.2 Location
Raised characters or symbols and Braille designations shall be placed immediately to the left of the control button to which the designations apply. Exception: Reserved....
-
Viewing Areas
Ensure the slope of clear floor or ground spaces and turning spaces does not exceed 1:48 (2 percent) in any direction....
-
This is a great unit but it's not "recessed", it's semi-recessed.
If you place this unit next to the accessible lavatory or other required clear space and don't allow room for the projection, it may interfere with the minimum required clear floor space...
-
Unobstructed: ADA Standard Section 308.2.1
Section 308.2.1 covers the current ADA Standards for unobstructed forward reach.
-
Coat Hooks and Shelves: ADA Standard Section 604.8.3
Section 604.8.3 covers the current ADA Standards for coat hooks and shelves in an ambulatory accessible compartment.
-
Coat Hooks and Shelves: ADA Standard Section 603.4
Section 603.4 covers the current ADA Standards for coat hooks and shelves in toilet and bathing rooms.
-
11B-308.2.1 Unobstructed
Where a forward reach is unobstructed, the high forward reach shall be 48 inches (1219 mm) maximum and the low forward reach shall be 15 inches (381 mm) minimum above the finish floor or...
-
§ 37.169 Process to be used by public entities providing designated public transportation service in considering requests for reasonable modification
[See subsections ...]
- Tile Tech Pavers® Porcelain Pavers™ Series
-
RECOMMENDED CHANGE
medical devices, requires a similar instability test in section 9.4.2.3: ME EQUIPMENT having a mass of 25 kg or more, other than FIXED ME EQUIPMENT that is intended to be used on the floor...
-
II-6.2100 General
Public entities may choose from two design standards for new construction and alterations....
-
Thresholds at Exterior Doors/Thresholds to Balconies or Decks
This was a particular concern among commenters from the South Florida building industry, who stated that the 3/4" height is ineffective for upper floors of high rise buildings in a coastal...
-
Conflict with Local Accessibility Codes
The commenter stated that the State of Washington's accessibility code may require installation of a ramp, and that the ramp may then create an accessible entrance for the ground floor,...
-
Standard Stall
Recommendation: Ceiling-mounted partitions are a good idea because toe clearance is not interrupted by vertical supports [sic] Because floor-mounted toilets commonly project further...
-
4.3.8 Operating forces
From these data, we can only make some broad conclusions for design and standards based on a large sample of people with relatively severe disabilities....
-
Width and Length: ADA Standard Section 1002.4.4.1
Wheelchair spaces shall provide a clear width of 30 inches (760 mm) minimum and a clear length of 48 inches (1220 mm) minimum measured to 9 inches (230 mm) minimum above the floor surface...
-
11B-1002.4.4.1 Width and length
Wheelchair spaces shall provide a clear width of 30 inches (762 mm) minimum and a clear length of 48 inches (1219 mm) minimum measured to 9 inches (229 mm) minimum above the floor surface...
-
11B-411.2.1.7.4 Adjacency assignment
Exception: The most adjacent elevator serving the selected floor shall be assigned by hall call consoles located outside the elevator landing....
-
233 Residential Facilities
1991 Standards for Accessible Design 2010 Standards for Accessible Design What’s New/Different Additional Requirements...
-
11B-604.8.3 Coat hooks and shelves
Shelves shall be located 40 inches (1016 mm) minimum and 48 inches (1219 mm) maximum above the finish floor....