The booklet cannot follow you around the block to say, "Yes, this block really does have four corners, but you were off course when you went around one of the corners, and you didn't recognize...
Search Results "Clearance Around Base"
Filters
Commonly Searched Documents
-
Care and Feeding of the Long White Cane: Instructions in Cane Travel for Blind People by Thomas Bickford
-
4. Comparison of Proposed Technical Provisions Applicable to Shared Use Paths and AASHTO Guide
desirable vertical clearance to obstructions is 10 ft (3.0 m)....
-
AbleThrive
AbleThrive is a platform that sources high-quality content related to living well with a disability from people, organizations and hospitals around the world....
-
11B-235.2 Boat slips
This number is based on the specification in Section 11B-235.2 that each 40 feet (12 m) of boat slip edge, or fraction thereof, counts as one boat slip....
-
11B-233.3.1.2.6.3 Test number two, site analysis test
Determine the requirement of providing an accessible route to planned multifamily dwellings based on the topography of the existing natural terrain....
-
4.1 Wheeled Mobility Device Dimensions
For example, in the U.S. standards, only occupied length is shown whereas the width is based on the device alone....
-
703.2.7 Character Spacing
Where characters have other cross sections, spacing between individual raised characters shall be 1/16 inch (1.6 mm) minimum and 4 times the raised character stroke width maximum at the base...
-
Health or Safety Defense
An assessment of "direct threat" must be strictly based on valid medical analyses and/or other objective evidence, and not on speculation....
-
4.5 Standards Necessary for Health and Safety: A "Direct Threat"
risk of substantial harm; the specific risk must be identified; it must be a current risk, not one that is speculative or remote; the assessment of risk must be based...
-
11B-404.3.1 Clear width
The minimum clear width for automatic door systems in a doorway shall be based on the clear opening provided by all leaves in the open position....
-
703.2.7 Character Spacing
Where characters have other cross sections, spacing between individual raised characters shall be 1/16 inch (1.6 mm) minimum and 4 times the raised character stroke width maximum at the base...
-
703.2.7 Character Spacing
Where characters have other cross sections, spacing between individual raised characters shall be 1/16 inch (1.6 mm) minimum and 4 times the raised character stroke width maximum at the base...
-
Team Player Seating Areas
Team Player Seating Areas Where provided, fixed team or player seating areas must contain the number of wheelchair spaces and companion seats required by ADAAG (based on the number of...
-
703.2.7 Character Spacing
Where characters have other cross sections, spacing between individual raised characters shall be 1/16 inch (1.6 mm) minimum and 4 times the raised character stroke width maximum at the base...
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions Measurement Range Minimum in Inches Maximum in Inches Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm)...
-
BENEFITS AND COSTS: OVERVIEW
BENEFITS AND COSTS: OVERVIEW Based on our analysis, we determined that transfer surface height requirements lower than 19 inches would increase the cost of designing and manufacturing...
-
F247.1 General
A trail can have more than one managed use based on a management decision to allow other uses on the trail....
-
QUESTION: WHAT LIMITATIONS CAN A PVO IMPOSE WITH RESPECT
TO CARRYING A SERVICE ANIMAL?
Such safety requirements must be based on actual risks and not on mere speculation, stereotypes, or generalizations about individuals with disabilities....
-
F235.2.1 Dispersion
Types of boat slips are based on the size of the boat slips; whether single berths or double berths, shallow water or deep water, transient or longer-term lease, covered or uncovered; and...
-
Example 2: Without Cooking Facilities
The break room, however, shall comply with applicable provisions of TAS based on the elements provided....
-
235.2.1 Dispersion
Types of boat slips are based on the size of the boat slips; whether single berths or double berths, shallow water or deep water, transient or longer-term lease, covered or uncovered; and...
-
1. Is my employer allowed to fire me because I have a mental health condition?
Before an employer can reject you for a job based on your condition, it must have objective evidence that you can't perform your job duties, or that you would create a significant safety...
-
T702.4 Character Height
Character height shall be based on the uppercase letter “I”....
-
Use of the ISA Under the ABA
The Access Board is responsible for making sure that modifications and waivers are based on findings of fact and are consistent with the ABA....
