B-279 ClassicSeries® Surface-Mounted Waste Receptacle Satin-finish stainless steel. Bottom edges hemmed for safety....
Search Results "End Transfer Surface"
Filters
Commonly Searched Documents
-
Bobrick B-279 ClassicSeries® Surface-Mounted Waste Receptacle
-
Bobrick TrimLineSeries ADA Surface-Mounted Hand Dryer B-7128.115V
Durable, 22-gauge galvanized steel with exposed surface, type 304 satin-finish stainless steel cover having #4 satin-finish vertical grain with black plastic trim, automatic sensor, dual...
-
Picnic Tables [1011.2 and 1011.4]
Knee clearance must be at least 30 inches wide and 8 inches deep at 27 inches above the ground surface....
-
11B-1008.2.3 Water play components
Exceptions: Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302,...
-
4.32 SEATING, TABLES, AND WORK SURFACES
[See subsections ...]
-
4.29.2* TACTILE WARNINGS ON WALKING SURFACES
(Reserved).
-
A4.29.2 TACTILE WARNINGS ON WALKING SURFACES
(Reserved).
-
A4.32 SEATING, TABLES, AND WORK SURFACES
[See subsections ...]
-
11B-809.9.7 Exposed pipes and surfaces
Exposed water supply and drain pipes under sinks and lavatories shall comply with Section 11B-606.5.
-
Armor-Tile Tactile Systems Cast In Place Detectable Warning Surface System
Armor-TileTM Cast in Place is the world leader in tactile walking surface indicators systems....
-
Bobrick TrimLineSeries ADA Surface-Mounted Hand Dryer B-7128.230V
Durable, 22-gauge galvanized steel with exposed surface, type 304 satin-finish stainless steel cover having #4 satin-finish vertical grain with black plastic trim, automatic sensor, dual...
-
Height of Tables or Counters [4.32.4]
Height of Tables or Counters [4.32.4] Counter and table surface heights (28 to 34 inches) should be specified in consideration of the intended use....
-
Detectable Warning Surfaces on Boarding Platforms Used by Buses and Rail Vehicles, and Boarding and Alighting Areas Used by Rail Vehicles (Section-by-Section Analysis)
Detectable Warning Surfaces on Boarding Platforms Used by Buses and Rail Vehicles, and Boarding and Alighting Areas Used by Rail Vehicles (Section-by-Section Analysis) The 1991 ADAAG...
-
CRL PR40 Series Adjustable Spring Power Surface Mounted Door Closers
08 7100 CRL DC50 Series ANSI Grade 1 Surface Mounted Door Closers Applicable for Doors Ranging From 26" to 54" Wide and 33 to 264 Pounds Dual Valve Closing and Latching Speed Control...
-
Access-Able Designs Rear Mount Tub Transfer Bench w/o Legs SH-414
Stainless steel frame holds up to 250lbs. Mounts most bathtub walls without the need for wall re-enforcement (with proper mounting hardware). Available with...
-
29. Please indicate what the length of time was between the installation of the trail surface material and the first necessary repair
Please indicate what the length of time was between the installation of the trail surface material and the first necessary repair: 1 month 3 months 6 months...
-
Location: ADA Standard Section 409.3.2
Section 409.3.2 covers the current ADA Standards for the location of private residence elevator doors.
-
CONTENTS
An Increasing number of Health Care Providers are Transitioning to Adjustable Height Tables Available data do not support departing from the currently accepted standard of 19-Inch transfer...
-
1017.4 Passing Spaces
Where the full length of a trail does not fully comply with 1017, a passing space shall be located at the end of the trail segment that fully complies with 1017....
-
1017.4 Passing Spaces
Where the full length of a trail does not fully comply with 1017, a passing space shall be located at the end of the trail segment that fully complies with 1017....
-
I. Introduction
The purpose of this Minority Report is to make a formal recommendation for a minimum transfer surface low height of 19 inches for diagnostic imaging medical equipment....
-
Seat: ADA Standard Section 607.3
Section 607.3 covers the current ADA Standards for seats in a bathtub.
