Compatibility M01.4.1 Clearance in Base Proposed requirement: The base of the equipment shall provide a clearance 44 inches (1120 mm) wide minimum, 6 inches (150 mm) high minimum measured...
Search Results "Unit of Measurement"
-
M301.4 Lift Compatibility
-
A4.5.1 General
While the dynamic coefficient of friction during walking varies in a complex and non-uniform way, the static coefficient of friction, which can be measured in several ways, provides a close...
-
General: ADA Standard Section 403.1
Section 403.1 of the ADA Standards covers information in the current ADA Standards for walking surfaces that are part of an accessible route.
-
Platform Lifts: ADA Standard Section 207.2
Section 207.2 covers scoping requirements in the most current ADA Standards for platform lifts used as part of an accessible means of egress.
-
11B-805 Medical care and long-term care facilities
treatment rooms refer to all patient care areas and include but are not limited to: exam rooms, treatment rooms, imaging rooms, operating rooms, emergency rooms, post anesthesia recovery rooms/units...
-
4. FACILITIES IN OTHER COUNTRIES
Facilities in other countries for which the United States contributes a portion of the construction cost but does not control design criteria (such as NATO-funded facilities) need not comply...
-
Forward Approach
Clearances for a forward approach are required at cantilevered units....
-
SETTLEMENT AGREEMENT BETWEEN THE UNITED STATES OF AMERICA AND BLOCKBUSTER INC. DEPARTMENT OF JUSTICE COMPLAINT NUMBER 202-35-231
[See subsections ...]
-
SETTLEMENT AGREEMENT BETWEEN THE UNITED STATES OF AMERICA AND ATLANTA'S JOHN MARSHALL LAW SCHOOL UNDER THE AMERICANS WITH DISABILITIES ACT
[See subsections ...]
-
DISPUTES AND ENFORCEMENT
The United States may review compliance with this Consent Decree at any time and may enforce this Consent Decree if the United States believes that this Consent Decree or any requirement...
- Delta Touch2O® Technology by Delta Faucet
-
Transient Lodging
Transient lodging does not include residential dwelling units intended to be used as a residence, inpatient medical care facilities, licensed long-term care facilities, detention or correctional...
-
Scope: ADA Standard Section 201.1
Section 201 discusses the scope of the ADA Standards.
-
4.35.5 Mirror
Where mirrors are provided in dressing rooms of the same use, then in an accessible dressing room, a full-length mirror, measuring at least 18 in wide by 54 in high (460 mm by 1370 mm),...
-
Question 23
The Department seeks input regarding the impact the measures being contemplated by the Department with regard to accessible equipment and furniture will have on small entities if adopted...
-
7c.
Is there clear maneuvering floor space in front of each accessible door (see Figure 25 in the appendix for measurements) and on the pull side, is there at least 18 inches clear floor space...
-
M303.2.6 Edge Protection
Where wheelchair spaces are provided on a platform raised more than 1 ½ inches (38 mm) in height, edge protection 2 inches (51 mm) high minimum measured from the surface of the platform...
-
Sec. 12205. Attorney's fees. [Section 505]
In any action or administrative proceeding commenced pursuant to this chapter, the court or agency, in its discretion, may allow the prevailing party, other than the United States, a reasonable...
-
Forward Approach
Forward Approach Clear floor space is required to the face of the unit; a portion can be provided below the unit where clearance is available for toes/knees....
- Seton Pavement Tool Plastic Graphic Stencils - ISA Symbol (California DOT) S-3048 D - PP261
- American Specialties Compact Rectangular Phenolic Fold-Up Shower Seat 8203
- Seton Optima Men Restroom Sign
- Seton Directional Entrance Sign - Left Arrow
- Seton Pavement Tool Plastic Graphic Stencils - ISA Symbol (Texas DOT) S-3148 D - PP262