This includes replacement of existing pay phones with units of different types, relocating existing pay phones, or installing new pay phones where none had previously been located....
Search Results "Unit of Measurement"
Commonly Searched Documents
-
Alterations
-
TTY Access at Wheelchair Accessible Phones
It is possible for a single unit to serve both people who use wheelchairs and those who use text telephones with careful design and placement of a standard TTY adjacent to an accessible...
-
HOUSING
A building, facility, or portion thereof, excluding inpatient health care facilities, that contains one or more dwelling units or sleeping accommodations....
-
IV. COMPENSATORY RELIEF FOR COMPLAINANTS AND RELEASE
Within thirty (30) days of the effective date of this Agreement, the United States will send, return receipt requested, the release form attached hereto as Attachment “B” to each of the...
-
BACKGROUND
BACKGROUND The Parties to this Settlement Agreement are the United States of America and the City of Woodlake, California (“City”)....
-
11B-203.8 Residential facilities
In residential facilities, common use areas that do not serve residential dwelling units required to provide mobility features complying with Sections 11B-809.2 through 11B-809.4 or adaptable...
- Diversified Woodcrafts 9010 ARM Lab Table Accessory
-
4(2)(a)
(a) In single-story dwelling units with lofts, all spaces other than the loft are on an accessible route....
-
Section 2. Building
"Building" means a structure, facility or portion thereof that contains or serves one or more dwelling units....
-
§100.201 Building
Building means a structure, facility or portion thereof that contains or serves one or more dwelling units....
-
M301.2.1 Adjustability
Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A....
-
M302.2.1 Adjustability
Transfer surfaces shall be adjustable in height measured from the floor to the top of the uncompressed transfer surface and shall provide the following: A....
-
Floor Designations
The proposed rule specified that tactile floor designations at the hoistway be 60 inches above the floor, measured from the baseline of the characters (407.2.4)....
-
Accessible Pool Stairs
ADAAG provisions for stairs include the requirement that all steps have uniform riser heights and uniform tread widths of not less than 11 inches, measured from riser to riser....
-
§104.44(c) Course examinations
student's achievement in the course, rather than reflecting the student's impaired sensory, manual, or speaking skills (except where such skills are the factors that the test purports to measure...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
2 Method
The two main dependent measures were: Whether the detectable warnings could be seen from distances between 2.44 m (8ft) and 7.92 m (26 ft)....
-
903.4 Back Support
Back support shall be 2 1/2 inches (64 mm) maximum from the rear edge of the seat measured horizontally. ...
-
11B-604.7.1 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
-
§ 38.125(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, when measured on level ground, for a maximum rise of 3 inches, and the transition from station...
-
§ 38.83(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8 measured on level ground, for a maximum rise of 3 inches, and the transition from the station platform...
-
§ 38.95(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, when measured on level ground, for a maximum rise of 3 inches, and the transition from station...
-
11B-604.7.1 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
- Clarity AL10 Visual Alert System