UPDC will cooperate fully with the United States’ efforts to monitor compliance with this Agreement, including but not limited to, providing the United States with reasonably requested information...
Search Results "Unit of Measurement"
-
Miscellaneous Provisions
-
§100.307(g)
(g) If the occupants of a particular dwelling unit refuse to comply with the age verification procedures, the housing facility or community may, if it has sufficient evidence, consider the...
- AJW Architectural Products US130-A Series US130-A12 12" Exposed Flange, 1.5" Diameter Security Grab Bar - Configuration A
-
Character Specifications
For those with non-rectangular cross sections, the stroke thickness was specified to be 15% maximum of the character height (measured at the top of the cross section) and 10% to 30% (measured...
-
5.8.1.1 Clear Platform Size Recommendation
on wheeled mobility devices shown in the table below.4 Table 5.8.1.1 Wheelbase Measurements on Wheeled Mobility Devices Table !...
-
Signatures and Contact Information Page
Vadas UNITED STATES DISTRICT COURT JUDGE By their signatures below, the Parties respectfully consent to the entry of this Consent Decree....
-
D. INDEPENDENT LICENSED ARCHITECT
hundred eighty (180) days of the entry of this Consent Decree, the County will retain an Independent Licensed Architect (“ILA”), pre-approved initially and continually approved by the United...
- Access Board: Sales and Service Counters
- Access Board: Signs
-
M303.2.2 Width
EXCEPTION: Wheelchair spaces located on raised platforms shall be permitted to be 32 inches (815 mm) wide minimum to a height of 4 inches (100 mm) measured from the platform surface....
-
C. Parking Slope
.: when measured as shown on the Tools & Techniques page , is the critical dimension 1/2" or less)?...
-
5.1.5 Floor Height
Where the floor at the entrance to the camp shelter is elevated above the ground surface, the floor shall be 17 (430 mm) high minimum to 19 inches (485 mm) high maximum measured from the...
-
2. b. i. Clear door openings
Clear openings of doorways with swinging doors shall be measured between the face of the door and the stop, with the door open 90° degrees.xiv...
-
Cross Slope
The percentage of rise to length, which is the difference in elevation, when measuring the trail tread from edge to edge perpendicular to the direction of travel This may be expressed as...
-
5.1.5 Floor Height
Where the floor at the entrance to the camp shelter is elevated above the ground surface, the floor shall be 17 (430 mm) high minimum to 19 inches (485 mm) high maximum measured from the...
-
Summary of Major Provisions
Requires camping units and picnic units with mobility features to provide choices of units comparable to, and integrated with, those available to others....
- Inclusion Solutions Offset Door Hinge
-
PARTIES
The parties to this Settlement Agreement ("Agreement") are the United States of America ("United States") and Blockbuster (collectively, "the Parties")....
-
16(b)
(b) The United States will provide HWI with the Survey Instrument referenced in subparagraph 16(a) within 15 days of the Consent Decree Date....
-
11B-705.1.1.2 Dome spacing
detectable warning surface shall have a center-to-center spacing of 2.3 inches (58 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch (16.5 mm) minimum, measured...
-
703.3.1 Dimensions and Capitalization
Table 703.3.1 Braille Dimensions Measurement Range Minimum in Inches Maximum in Inches Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm)...
-
§35.130(f) (Section-by-Section Analysis)
Paragraph (f) provides that a public entity may not place a surcharge on a particular individual with a disability, or any group of individuals with disabilities, to cover any costs of measures...
-
1017.5 Tread Obstacles
This section requires obstacles to not exceed 1/2 inch in height measured vertically to the highest point....
-
Energy Consumption During Ambulation
Measurements were recorded for subjects walking on the Straight and Turning Courses....
