It is not enough to simply show that a particular bathroom stall, for example, is less than the required width. The approximate extent of any shortfall must be proven....
Search Results "Compartment Width"
-
2. New Construction and Alterations
-
1. Abdomen depth (AD)
., combinations of knee clearance height or depth, foot clearance height or depth, occupied width, etc.) then a multivariate analysis which involves simultaneous consideration of multiple...
-
Perpendicular Curb Ramps (R304.2) (Section-by-Section Analysis)
Transportation officials have reported that the 10 percent maximum slope for the flared sides can make it difficult to provide two perpendicular curb ramps at some street corners due to the width...
-
704.11 Parapets
the roof/ceiling framing elements are parallel to the walls, such framing and elements supporting such framing shall not be of less than 1-hour fire-resistance-rated construction for a width...
-
ADA Requirements
And, the Standards require doors with 32 inches of clear passage width, ramps and curb cuts for persons who use wheelchairs, crutches, and other mobility aids....
-
11B-504.4.1 Contrasting stripe
The stripe shall extend the full width of the step or upper approach and shall be of material that is at least as slip resistant as the other treads of the stair....
-
Road Roughness Analysis
WT also addresses the issue of lost time information, which occurs in PSD analysis, by using short width and long width windows at high and low frequencies respectively....
-
Design of Shared Use Paths, Street Intersections, and Midblock Crossings
Width C. Shoulders and Sideslopes 1. Width and Slope of Shoulders 2. Horizontal Clearance to Obstructions 3. Sideslopes D. (Traffic) Barriers and Railings E....
-
4.4 Knee and Toe Clearances
620-640 X 500-650 Reduction Angle 1:6 X X X Width...
-
C. Raised Porches Are Part Of the Store That Must Be Made Accessible and Located On An Accessible Route
compliant walking surfaces, slopes no greater than 1:20 in the direction of travel and cross slopes no greater than 1:48, vertical changes in level no higher than ¼”, and sufficient clear width...
- AJW Architectural Products U716 Series 16"W x 20"H Channel Frame Mirror w/ Mounted Shelf - Plate Glass Surface
- Oval Fire Products 10 LB Chemical ABC Fire Extinguisher A-10JABC
- AJW Architectural Products U705 Series 16"W x 30"H Angle Frame Mirror w/ Mounted Shelf - Plate Glass Surface
- Door King Inc. 1150 Overhead Gate and Door opener
- Stanley Access Technologies Dura-Care 7200 Manual Sliding Door
- AccessRec All Terrain PVC Beach Chairs
- Panda UTS.60 Thermally Broken ULTRA Folding Door System
- Panda TS.83 Thermally Broken Multi-Slide Door System
-
Doors in a Series
Section 404.2.6 specifies the minimum separation between doors and gates in series (48 inches plus the width of doors or gates swinging into the space)....
-
4. Exception from the Requirements of M301 for Certain Examination Chairs that Comply with M302
These commenters argued that requiring the equipment to be designed to accommodate transfer in both positions would not achieve any objective benefit and would impose transfer surface width...
-
Trailhead Information Signs [F216.13 and 1017.10]
new trail information signs must include the following information: Length of the trail or trail segment Type of trail surface Typical and minimum trail tread width...
-
Executive summary
The minimum length and width included in the clear floor space requirements located adjacent to the ride seat or transfer device do not accommodate many wheeled mobility device users....
-
T402 Ramps and Bridgeplates
technical requirements for ramps and bridgeplates in the 2016 Non-Rail Vehicle Guidelines include provisions on design load, installation and operation, emergency operation, surfaces, clear width...
-
Getting From Here to There—Outdoor Recreation Access Routes
Design outdoor recreation access routes to meet technical requirements for running and cross slopes, resting intervals, surface, clear tread width, passing spaces, tread obstacles, protruding...