All hinges to be with adjustable spring tension with nonremovable pins as listed in hardware groupings and shall be provided with the width that will clear trim to allow for maximum degree...
Search Results "Clear Width at Turn"
- TownSteel THSP179 Standard Duty Spring Hinge
-
11B-502.6.3 Location
Signs shall be permanently posted either immediately adjacent to the parking space or within the projected parking space width at the head end of the parking space....
-
11B-502.6.3 Location
Signs shall be permanently posted either immediately adjacent to the parking space or within the projected parking space width at the head end of the parking space....
-
Showers
Several commenters requested that the final Guidelines provide dimensions on the appropriate width and height of showers and shower doors....
- Lutron Sivoia QED Kirbé Vertical Motorized Drapery System
-
1010 Shooting Facilities with Firing Positions
This section requires turning space at firing positions required to be accessible....
- LaCantina Multi-slide Contemporary Clad Sliding Door System
-
Toilet Room Doors
Sections 4.22.2 and 4.22.3 of the 1991 Standards and Section 603.2.3 of the 2010 Standards permit the doors of all toilet or bathing rooms with in-swinging doors to swing into the required turning...
-
Water Hydrants
This clear space must be located with its long side adjoining (and may overlap) an outdoor recreation access route, trail, beach access route, or another clear ground space....
- Stanley SB600 Bifolding Door
-
2013 & 2016 CBC Answer
Based on the attached diagram, the accessible parking and its access aisle are adjacent to another parking space; therefore the width measurement shall be taken from centerline of the markings...
-
802.1.5 Overlap
The term "circulation paths" used in 802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
-
Recumbent Tricycles
However, when turning at higher speeds, these vehicles can be unstable....
- Lift-U® Fold-Out Rising Floor Ramp
-
11B-802.1.5 Overlap
The term "circulation paths" used in 802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
-
802.1.5 Overlap
The term "circulation paths" used in 802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
-
802.1.5 Overlap
The term "circulation paths" used in Section 802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
-
11B-802.1.5 Overlap
The term "circulation paths" used in 802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
- Oval Window Audio Satellite III — Large Area Induction Hearing Loop System
-
1118B.3
SECTION 1118B - SPACE ALLOWANCE AND REACH RANGES 1118B.3 Wheelchair turning space. ...
-
11B-802.1.5 Overlap
The term "circulation paths" used in Section 11B-802.1.5 means aisle width required by applicable building or life safety codes for the specific assembly occupancy....
-
Guidelines for Requirement 3
(2) For doors within individual dwelling units, the Department has retained, in the final Guidelines, the design specification that a door with a clear opening of at least 32 inches...
-
Elevated Dune Crossings
The clear width of elevated dune crossings may be narrower than the rest of the beach access route, but must be at least 48 inches (1,220 millimeters)....
-
1016.1 General
The technical requirements address the surface of outdoor recreation access routes, passing spaces, and resting intervals (1016.2); the clear width of outdoor recreation access routes (1016.3...