The shelf must provide a vertical clearance of at least 6 inches so that different types of portable TTY devices can be connected....
Search Results "Grab Bar Clearance"
Commonly Searched Documents
-
Shelf and Outlet
-
Horizontal Alignment
Horizontal Alignment The minimum clearance to an obstruction that should be provided along a horizontal curve is a function of the stopping sight distance and radius of the curve....
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding No Weight - Forward Approach Scooter
reaching over an obstruction in relation to the forward-most point, and the negative range implying that the reach target is brought closer to the person (such as on a table with knee clearance...
-
5.7 File a Lawsuit
You can find a lawyer through a referral organization (check your state Bar Association) or disability rights organizations....
-
IDEA Center
Clearances were pre-measured on the floor of the test site using tape and marker....
- Mockett SDH1-SSS Sliding Door Hardware Set
- Pilot Rock M-32/17 Campfire Ring
-
§35.130(b)(8) (Section-by-Section Analysis)
It prohibits overt denials of equal treatment of individuals with disabilities, or establishment of exclusive or segregative criteria that would bar individuals with disabilities from participation...
-
Manual vs. Power (RMS Values)
However, Figure 20 does show the average seat RMS data for all of the surfaces with 95 percent confidence bars. Figure 20: Seat RMS values with 95 percent confidence bars ...
-
III−1.1000 General
Are continuing education courses sponsored by a State bar association subject to title III? Yes....
-
Standing Supports (M304.3 and M305.3)
Standing supports that adjust from horizontal to vertical positions and at angles in between, such as a bar that folds up and locks into multiple positions, can be used....
-
Expert opinion on the current knowledge
This item encompassed for example the use of handholds, grab bars, or other environmental fixtures designed to facilitate a transfer to a target surface. 8. ...
-
11B-104.1.1 Construction and manufacturing tolerances
Where the requirement states a specified range, such as in 609.4 where grab bars must be installed between 33 inches and 36 inches above the floor, the range provides an adequate tolerance...
-
III-4.4500 Priorities for barrier removal
. , lowering towel dispensers or installing grab bars) in each restroom?...
-
11B-104.1.1 Construction and manufacturing tolerances
Where the requirement states a specified range, such as in 609.4 where grab bars must be installed between 33 inches and 36 inches above the floor, the range provides an adequate tolerance...
- UpScale by Medical Accessibility - Adjustable Height Exam Table with Built-in Scale
- Caroma® USA Sydney Smart 305 Easy Height Elongated 1 Piece Toilet
- Caroma® USA Caravelle Smart 270 One Piece Toilet
- Symmons Duro® Tub Shower System 3S603-H321-V
-
Edge Protection
Toe clearance must be at least 30 inches wide and a minimum of 9 inches above the ground or deck surface beyond the railing....
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding No Weight - Forward Approach Manual Wheelchair
reaching over an obstruction in relation to the forward-most point, and the negative range implying that the reach target is brought closer to the person (such as on a table with knee clearance...
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding 5 lb Weight - Forward Approach Scooter
reaching over an obstruction in relation to the forward-most point, and the negative range implying that the reach target is brought closer to the person (such as on a table with knee clearance...
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding No Weight - Forward Approach Power Chair
reaching over an obstruction in relation to the forward-most point, and the negative range implying that the reach target is brought closer to the person (such as on a table with knee clearance...
-
Landings [§405.7]
Handrails, edge protection, vertical posts and other elements cannot obstruct or overlap the minimum 60” by 60” clearance....