xx Shelves: “If the clear floor space allows a parallel approach by a person in a wheelchair and the distance between the wheelchair and the shelf exceeds 10 inches, the maximum high...
Search Results "High Speed Rail"
-
3. FIXTURES and HARDWARE
-
Mounting Location and Height [4.30.6]
Recommendation: At signs containing pictograms or other non-tactile information, this should be measured to the centerline of the raised/ Braille portion so that it is not too low (or high...
-
INFORMATION REQUIREMENTS OF PEDESTRIANS WITH VISION DISABILITIES
In a review of accessible pedestrian signal devices, Bentzen and Tabor (12) provide a high level analysis of intersection information requirements of pedestrians who are blind....
-
II. DISCUSSION
In fact, a sales or service counter that is uniformly less than 36 inches high satisfies 904.4.1 or its exception....
-
2.2 Lighting Conditions
Also, these two aspects of the lighting conditions were not significantly related to the probability of the participant giving a detectable warning a high conspicuity rating....
-
5. Conclusions
Engineered surfaces showed that there is a high correlation between surface roughness and the WBVs which WC users are exposed to as well as their perceived comfort level while traveling...
-
4.16.6 Dispensers
As a result, the dispenser was located 24" above the floor, 5" higher than the minimum height in ADAAG, and 42" from the rear wall (Figure 13), which would have been too high and too far...
-
Identification [§216.5, §502.6]
Signs must be at least 60” high measured to the bottom edge so that they are visible while vehicles are parked in a space....
-
TEST NO. 3 – UNUSUAL CHARACTERISTICS TEST
Unusual characteristics include sites located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or code that...
-
§ 38.23(b)(5) Platform barriers
Each side of the lift platform which extends beyond the vehicle in its raised position shall have a barrier a minimum 11/2 inches high....
-
§ 38.159(b)(5) Platform barriers
Each side of the lift platform which extends beyond the vehicle in its raised position shall have a barrier a minimum 11/2 inches (13 mm) high....
-
TEST NO. 3 – UNUSUAL CHARACTERISTICS TEST
Unusual characteristics include sites located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or code that...
-
Issue 15: How can the potential conflict between the goals of zero net energy and accessibility for low vision persons be resolved?
the future is finding ways of creating less efficient facilities by decentralizing, in order to reduce the energy consumption in a hospital, for example, is to move out services that are high-energy...
-
308 Reach Ranges
These commenters, as well as the ANSI A117 Committee and the Little People of America, stated that the unobstructed high reach range requirement should be lowered to 48 inches to help meet...
-
General Comments (Preamble, Section-by-Section Analysis)
Numerous business groups have urged the Department not to adopt the proposed ADAAG as the accessibility standards, because the requirements established are too high, reflect the ‘‘state...
-
General Comments (Section-By-Section Analysis and Response to Comments)
Numerous business groups have urged the Department not to adopt the proposed ADAAG as the accessibility standards, because the requirements established are too high, reflect the "state of...
-
Congressional Findings of Discrimination
supplement the accessibility guidelines developed earlier for the Architectural Barriers Act to include “additional requirements, consistent with this Act, to ensure that buildings, facilities, rail...
-
5.4.3 Transfer Support Height for M301 and M302
The minimum height is consistent with the information provided by Midmark Corporation on examination tableside rails, and the maximum height is generally consistent with the height of grab...
-
R204 Pedestrian Access Routes (Section-by-Section Analysis)
Pedestrian access routes must be provided within: Sidewalks and other pedestrian circulation paths located in the public right-of-way; Pedestrian street crossings and at-grade rail...
-
The Roles of the Access Board and the Department of Justice
shall supplement the existing Minimum Guidelines and Requirements for Accessible Design for purposes of subchapters II and III of this chapter . . . to ensure that buildings, facilities, rail...
-
QUESTION: WHERE THE REQUIREMENTS OF SECTION 37.42 APPLY, WHICH CARS OF A TRAIN DOES A RAILROAD OPERATOR HAVE TO MAKE AVAILABLE TO PASSENGERS WITH DISABILITIES?
In some commuter rail systems, only two cars are open to be boarded by any passenger at a station....
-
PEMKO 5" Heavy Duty Threshold No. 1715
About Heavy Duty Thresholds Heavy-duty thresholds are ideal for heavy-duty, high-traffic and high weight-bearing applications, such as industrial facilities, schools, cafeterias, manufacturing...
-
Haws Fountain Skirt SK3HPS
Model SK3HPS is a wrap around matching high polished finished stainless steel cane touch skirt for installation on the high unit to comply with ADA protruding objects guidelines....
-
Ytterberg Scientific Inc. FloorPro® Floor Flatness Measurement Device
All Flatness Specifications The FloorPro® works with all three random traffic flatness specifications, as well as analysis of defined traffic wheeltracks in the narrow aisle areas of high...
