., daylight, high CCT, bright or dim light) aren’t good enough...
Search Results "High Speed Rail"
-
Mariana Figueiro, Ph.D., Program Director, Assistant Professor, The Lighting Research Center, Rensselaer Polytechnic Institute
-
Written Complaints Received after the Trip
[Sec. 382.65(b)(3)] You should provide all information regarding written complaints -- and in general -- in a polite and respectful manner as a matter of high standards of customer service...
-
Civil Lawsuits
This is a high threshold to meet. The prevailing party may also recover attorney’s fees at the court’s discretion....
-
232.2 General Holding Cells and General Housing Cells
For example, a shift area serving as a medium-security housing unit might be designated for a period of time as a high-security housing unit to meet capacity needs....
-
407.12.3.2.2 Knee and Toe Space (Section-by-Section Analysis)
The dimensions necessary to accommodate the full knee and toe space under ICT would be 27 inches high minimum, 25 inches deep maximum, and 30 inches wide minimum....
-
Public Address Systems and Microphones
"phantom" powered condenser microphones) accommodate speech over all frequencies (use wide frequency response microphones and avoid foam wind screens since they can filter out high...
-
3. FIXTURES and HARDWARE
xx Shelves: “If the clear floor space allows a parallel approach by a person in a wheelchair and the distance between the wheelchair and the shelf exceeds 10 inches, the maximum high...
-
Mounting Location and Height [4.30.6]
Recommendation: At signs containing pictograms or other non-tactile information, this should be measured to the centerline of the raised/ Braille portion so that it is not too low (or high...
-
INFORMATION REQUIREMENTS OF PEDESTRIANS WITH VISION DISABILITIES
In a review of accessible pedestrian signal devices, Bentzen and Tabor (12) provide a high level analysis of intersection information requirements of pedestrians who are blind....
-
II. DISCUSSION
In fact, a sales or service counter that is uniformly less than 36 inches high satisfies 904.4.1 or its exception....
-
2.2 Lighting Conditions
Also, these two aspects of the lighting conditions were not significantly related to the probability of the participant giving a detectable warning a high conspicuity rating....
-
5. Conclusions
Engineered surfaces showed that there is a high correlation between surface roughness and the WBVs which WC users are exposed to as well as their perceived comfort level while traveling...
-
4.16.6 Dispensers
As a result, the dispenser was located 24" above the floor, 5" higher than the minimum height in ADAAG, and 42" from the rear wall (Figure 13), which would have been too high and too far...
-
Identification [§216.5, §502.6]
Signs must be at least 60” high measured to the bottom edge so that they are visible while vehicles are parked in a space....
-
TEST NO. 3 – UNUSUAL CHARACTERISTICS TEST
Unusual characteristics include sites located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or code that...
-
§ 38.23(b)(5) Platform barriers
Each side of the lift platform which extends beyond the vehicle in its raised position shall have a barrier a minimum 11/2 inches high....
-
§ 38.159(b)(5) Platform barriers
Each side of the lift platform which extends beyond the vehicle in its raised position shall have a barrier a minimum 11/2 inches (13 mm) high....
-
TEST NO. 3 – UNUSUAL CHARACTERISTICS TEST
Unusual characteristics include sites located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or code that...
-
Issue 15: How can the potential conflict between the goals of zero net energy and accessibility for low vision persons be resolved?
the future is finding ways of creating less efficient facilities by decentralizing, in order to reduce the energy consumption in a hospital, for example, is to move out services that are high-energy...
-
308 Reach Ranges
These commenters, as well as the ANSI A117 Committee and the Little People of America, stated that the unobstructed high reach range requirement should be lowered to 48 inches to help meet...
-
General Comments (Preamble, Section-by-Section Analysis)
Numerous business groups have urged the Department not to adopt the proposed ADAAG as the accessibility standards, because the requirements established are too high, reflect the ‘‘state...
-
General Comments (Section-By-Section Analysis and Response to Comments)
Numerous business groups have urged the Department not to adopt the proposed ADAAG as the accessibility standards, because the requirements established are too high, reflect the "state of...
-
Congressional Findings of Discrimination
supplement the accessibility guidelines developed earlier for the Architectural Barriers Act to include “additional requirements, consistent with this Act, to ensure that buildings, facilities, rail...
-
5.4.3 Transfer Support Height for M301 and M302
The minimum height is consistent with the information provided by Midmark Corporation on examination tableside rails, and the maximum height is generally consistent with the height of grab...