Projections from walls of Type III, IV or V construction shall be of any approved material....
Search Results "Control End Wall"
-
704.2.2 Types III, IV and V construction
-
11B-411.4.10 Support rail
Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
-
4.9.4(3)
(3) The clear space between handrails and wall shall be 1‒1/2 in (38 mm)....
-
4.8.5(3)
(3) The clear space between the handrail and the wall shall be 1 - 1/2 in (38 mm)....
-
11B-411.4.10 Support rail
Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
-
11B-411.4.10 Support rail
Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
-
11B-813.2.1 Adult changing table
Adult changing tables shall be fixed to the floor or a wall and shall comply with Section 11B-813.2.1....
-
2. Background
These accessibility guidelines would adopt the definition of sidewalk in the Manual on Uniform Traffic Control Devices (MUTCD)....
-
Benches [1011.2]
However, armrests on both ends of a bench could prevent a person using a mobility device from being able to transfer from the device onto the bench....
-
Fishing piers and platforms. (Section-by-Section Analysis)
If gangways (where only one end of route is attached to land) and floating piers (where neither end is attached to land) are involved, a number of exceptions are provided from the general...
-
Fishing piers and platforms. (Section-by-Section Analysis)
If gangways (where only one end of route is attached to land) and floating piers (where neither end is attached to land) are involved, a number of exceptions are provided from the general...
- Bradley 2-Station Express Lavatory System MG-2
- Bradley 3-Station Express Lavatory System MG-3
-
M301.2.3 Transfer Sides
The configuration of stretchers will not allow for unobstructed access to a transfer surface located at either the foot end or head....
-
1. Sloped Surfaces
Rest one end of the level at the highest point of the sloped surface and lift the other end (see below) until the bubble is in the middle of the tube. This is the “level” position....
-
11B-234.3 Minimum number
Exceptions: Amusement rides that are controlled or operated by the rider shall not be required to comply with Section 11B-234.3....
-
11B-234.3 Minimum number
Exceptions: Amusement rides that are controlled or operated by the rider shall not be required to comply with Section 11B-234.3....
-
11B-104.1.1 Construction and manufacturing tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
- ADAEZ Pro Plus Automatic Door Opener Installation Video
- Williams Sound - PPA T45NET Introduction
- Williams Sound: PPA T45NET Installation
-
Kitchens and Kitchenettes
Section 4.34.6 requires a clearance between opposing base cabinets, counters, appliances, or walls of at least 40 inches except in a U-shaped kitchen where the minimum clearance is 60 inches...
- AJW Architectural Products UG120-U Series UG120-U 29" Swing-Up, 1.25" Diameter Grab Bar - Configuration U
- Pilot Rock TQ700 Square Frame Square Utility Table