The centerline of the text shall be a maximum of 6 inches (152 mm) from the centerline of the vehicle space and its lower corner at, or lower side aligned with, the end of the parking space...
Search Results "Control End Wall"
-
11B-812.9 Surface marking
-
11B-812.9 Surface marking
The centerline of the text shall be a maximum of 6 inches (152 mm) from the centerline of the vehicle space and its lower corner at, or lower side aligned with, the end of the vehicle space...
-
Benches [1011.2]
However, armrests on both ends of a bench could prevent a person using a mobility device from being able to transfer from the device onto the bench....
-
Fishing piers and platforms. (Section-by-Section Analysis)
If gangways (where only one end of route is attached to land) and floating piers (where neither end is attached to land) are involved, a number of exceptions are provided from the general...
-
Fishing piers and platforms. (Section-by-Section Analysis)
If gangways (where only one end of route is attached to land) and floating piers (where neither end is attached to land) are involved, a number of exceptions are provided from the general...
-
704.2.2 Types III, IV and V construction
Projections from walls of Type III, IV or V construction shall be of any approved material....
-
11B-411.4.10 Support rail
Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
-
4.9.4(3)
(3) The clear space between handrails and wall shall be 1‒1/2 in (38 mm)....
-
4.8.5(3)
(3) The clear space between the handrail and the wall shall be 1 - 1/2 in (38 mm)....
-
11B-411.4.10 Support rail
Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
-
11B-411.4.10 Support rail
Support rails complying with Section 11B-407.4.10 shall be provided on at least one wall of the car....
-
11B-813.2.1 Adult changing table
Adult changing tables shall be fixed to the floor or a wall and shall comply with Section 11B-813.2.1....
-
AJW Architectural Products UG120-U Series UG120-U 29" Swing-Up, 1.25" Diameter Grab Bar - Configuration U
Pivot Brackets: Dual supports fabricated of #18 ga square stainless steel tube with capped ends....
-
M301.2.3 Transfer Sides
The configuration of stretchers will not allow for unobstructed access to a transfer surface located at either the foot end or head....
-
1. Sloped Surfaces
Rest one end of the level at the highest point of the sloped surface and lift the other end (see below) until the bubble is in the middle of the tube. This is the “level” position....
-
11B-234.3 Minimum number
Exceptions: Amusement rides that are controlled or operated by the rider shall not be required to comply with Section 11B-234.3....
-
11B-234.3 Minimum number
Exceptions: Amusement rides that are controlled or operated by the rider shall not be required to comply with Section 11B-234.3....
-
11B-104.1.1 Construction and manufacturing tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
Section 307 Protruding Objects
This dryer protrudes more than 4" from the wall and is greater than 27" above the finish floor. Isn't this a violation of Section 307 Protruding Objects?...
-
Pilot Rock TQ700 Square Frame Square Utility Table
Model TQ700 Utility Tables are square tables designed with clean-cut square end frames and inlaid table planks. No benches are included with this utility table. ...
-
Pilot Rock T700 Square Frame Rectangular Utility Table
Model T700 Utility Tables are rectangular tables designed with clean-cut square end frames and inlaid table planks. No benches are included with this utility table. ...
-
Bobrick Surface-Mounted Toilet Tissue Dispenser for Two Rolls B-27460
Unit 14 1⁄8" (360mm) wide, projects 5 1⁄4" (135mm) from wall. No controlled delivery....
-
§382.143(b)
or more passenger seats, you must provide training meeting the requirements of §382.141(a) for all personnel who deal with the traveling public in connection with flights that begin or end...
