If all pedestrians using the parking facility are expected to share the vehicular lanes, then the ADA permits covered entities to use the vehicular lanes as part of the accessible route....
Search Results "Expected Maximum Flight Duration"
-
Access Aisle
-
IMPLICATION OF A 19-INCH MINIMUM STANDARD FOR THE HIGHEST POINT IN THE LOWEST ADJUSTABLE POSITION
It is not unreasonable to expect that table and chair manufacturers will seek to compete by offering products with greater degrees of adjustability. Figure 3....
-
Executive Order 12866 (Regulatory Planning and Review), DOT Regulatory Policies and Procedures, and Executive Order 13563 (Improving Regulation and Regulatory Review)
The costs of this rulemaking are expected to be minimal for two reasons....
-
3.6.1. Hardware Replacement
Public comments on the 2014 NPRM, as well as information provided by manufacturers, suggest that captioning and audio description hardware is expected to last about 10 years. ...
-
V. RESERVATION OF RIGHTS
Olympia’s planned Events Center or relocation shall fail to meet the schedule set forth in paragraph 13: (i) Olympia shall immediately provide written notice to the United States of such expected...
-
3.2 Microphone Location
In programs in which audience participat ion is expected (as in a large lecture), then a wireless FM microphone should be available for audience use....
-
Areas for further work
Of course, it was not expected that all of these would be included in any one industry's standards, but they do indicate the range and complexity of issues related to construction tolerances...
-
Protruding Objects
Protruding Objects Common Problem: In areas inside and outside the lodging facility where people are expected to walk, objects protrude too far from the side, from posts, or hang down...
- Delta Electronic Lavatory NS DEMD-301LF
- Pressalit Care VALUE Support Arm Fixed Height Swing Grab Bar
- Delta Electronic Lav with Mixer NS DEMD-311LF
-
1008.4.4 Entry Points and Seats
Where play components require transfer to entry points or seats, the entry points or seats shall be 11 inches (280 mm) minimum and 24 inches (610 mm) maximum from the clear floor or ground...
-
Gas Pump Force
Gas pump manufacturers indicated that the safety requirements for the operation of gas pump nozzles effectively preclude a maximum operating force of 5 pounds. Response....
-
705.1.2 Dome Spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 1.6 inches (41 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
R402.4 Reduced Vertical Clearance
The leading edge of the guardrail or barrier shall be located 685 mm (2.25 ft) maximum above the finish surface....
-
407.8.3 Forward Reach
Where a forward reach allows a reach over a portion of the ICT, the height of that portion of the ICT shall be 34 inches (865 mm) maximum....
-
11B-1009.4.3 Wall depth and length
The depth of the transfer wall shall be 12 inches (305 mm) minimum and 16 inches (406 mm) maximum....
-
407.12.3 Forward Reach
Where a forward reach allows a reach over a portion of the ICT, the height of that portion of the ICT shall be 34 inches (865 mm) maximum....
-
11B-608.3.3 Alternate roll-in type shower compartments
Grab bars shall be installed 6 inches (152 mm) maximum from adjacent walls....
-
1008.4.4 Entry Points and Seats
Where play components require transfer to entry points or seats, the entry points or seats shall be 11 inches (280 mm) minimum and 24 inches (610 mm) maximum from the clear floor or ground...
-
1009.5.6 Size
Each transfer step shall have a tread clear depth of 14 inches (355 mm) minimum and 17 inches (430 mm) maximum and shall have a tread clear width of 24 inches (610 mm) minimum....
-
605.2 Height and Depth
Urinals shall be the stall-type or the wall-hung type with the rim 17 inches (430 mm) maximum above the finish floor or ground....
-
608.3.3 Alternate Roll-In Type Shower Compartments
Grab bars shall be installed 6 inches (150 mm) maximum from adjacent walls....
-
705.1.2 Dome Spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 1.6 inches (41 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...