The Department expects that it will likewise be useful to public entities newly covered by the ADA. All public entities are required to do a self-evaluation....
Search Results "Expected Maximum Flight Duration"
-
§35.105 Self-evaluation (Section-by-Section Analysis)
-
Chapter 4: Hardware (Section-by-Section Analysis)
Yet, while new to the 255 Guidelines, these proposed hardware rules are generally not expected to have a significant cost impact....
-
DEPARTMENT OF TRANSPORTATION DISABILITY LAW GUIDANCE: Paratransit Requirements for §5311-Funded Fixed-Route Service Operated by Private Entities
If the state provides funding to XYZ Nonprofit Transit Service, expects XYZ to perform certain tasks with those funds, and memorializes these expectations in a subgrant agreement, then there...
-
Background
Building Officials, regardless of how conscientious, knowledgeable and hard-working, cannot be expected to find and correct every Building Code shortcoming any more than traffic enforcement...
-
11B-206.4.10 Medical care and long-term care facilities
Since there is no change to the wording of Subsection 11B-206.4.10, there is no reason to expect that OSHPD will change its interpretation. ...
-
11B-206.4.10 Medical care and long-term care facilities
Since there is no change to the wording of Subsection 11B-206.4.10, there is no reason to expect that OSHPD will change its interpretation. ...
-
Sides of Curb Ramps
Section 406.3 addresses the sides of curb ramps and specifies that side flares, where provided, have a slope of 1:10 maximum....
-
711.4.1 Through penetrations
Penetrating items with a maximum 6 inch (152 mm) nominal diameter shall not be limited to the penetration of a single fire-resistance-rated floor assembly provided that the area of the penetration...
-
405 Ramps
A 1:10 maximum slope is permitted for ramps with a rise of up to 6 inches, and a maximum 1:8 slope is allowed for ramps with a rise of up to 3 inches. Comment....
-
A1
Is a relatively level (1:50 or 2% maximum slope in all directions) access aisle provided adjacent and parallel to the side of the vehicle pull-up area?...
-
R409.4 Height
Top of gripping surfaces of handrails shall be 865 mm (2.8 ft) minimum and 965 mm (3.2 ft) maximum vertically above walking surfaces, ramp surfaces, and stair nosings....
-
Forward Approach
Forward Approach A maximum height of 48 inches is required for a forward reach....
-
4.24.5 Clear Floor Space
The clear floor space shall be on an accessible route and shall extend a maximum of 19 in (485 mm) underneath the sink (see Fig. 32)....
-
4.24.5 CLEAR FLOOR SPACE
The clear floor space shall be on an accessible route and shall extend a maximum of 19 in (485 mm) underneath the sink (see Fig. 32)....
-
§ 37.197(b)
subpart requires an entity purchasing or leasing a new OTRB to purchase or lease an accessible OTRB, OTRBs acquired through the actions listed in paragraph (a) of this section shall, to the maximum...
-
EQUIVALENT FACILITATION
Note: In determining equivalent facilitation, consideration shall be given to means that provide for the maximum independence of persons with disabilities while presenting the least risk...
-
1009.2.4 Seat Height
The height of the lift seat shall be designed to allow a stop at 16 inches (405 mm) minimum to 19 inches (485 mm) maximum measured from the deck to the top of the seat surface when in the...
-
1008.2.5.3.1 Handrail Gripping Surfaces
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 0.95 inch (24 mm) minimum and 1.55 inches (39 mm) maximum....
-
Multi-Cultural Independent Living Center of Boston, Inc. (MILCB) - Jamaica Plain, MA
We create opportunities for people with disabilities to achieve self-determination at their maximum level of independent functioning within their family and community environment....
-
Pre-Event Attendee Registration and Communications
As attendees to our conference may experience multiple chemical sensitivities, please refrain from wearing all perfumes and use fragrance-free, unscented personal care products for the duration...
-
Overview
Sub-base installation: date of installation, aggregate type, aggregate depth, cost of sub-base, manufacturer, contactor or staff completing installation, time duration for installation,...
-
Top Landings
The proposed rule specified that side flares of 1:12 maximum must be provided when space at the top of curb ramps is less than 48 inches long. This specification has been removed....
-
214 and 611 Washing Machines and Clothes Dryers
An exception will permit the maximum height for the tops of these machines to be 2 inches higher than the general requirement for maximum high reach over an obstruction....
-
Elevated Accessible Routes
inch (915 mm) clear width 32-inch (815 mm) narrowed width permitted for 24-inch (610 mm) length to accommodate features in the composite structure 12-inch (305 mm) rise maximum...
