Also, because other entrances – not the main entrance to the building – are commonly used as entry points to the polling place, especially at large facilities such as schools, permanent...
Search Results "Site Arrival Point"
Filters
Commonly Searched Documents
-
Parking
-
104 Conventions
the 2010 Standards provides that all dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points...
-
Section 1193.37 Information pass-through [1193.27 in the NPRM] (Section-by-Section Analysis)
Most manufacturers pointed out that the provision as proposed could require manufacturers to anticipate any possible code or protocol another party might devise and to pass it through....
-
V. Description of Steps Taken to Minimize the Significant Economic Impact Consistent with the Stated Objectives and Significant Alternatives Considered and Rejected.
The listserve was opened to the public to follow and many of the discussion points received from outside parties were also posted on the listserve....
-
382.19 May carriers refuse to provide transportation on the basis of disability?
account the nature, duration and severity of the risk; the probability that the potential harm will actually occur; and whether reasonable mitigating measures can reduce the risk to the point...
-
Issue 14: Inspection of contractor’s work - Beware of field changes!
The APS to cross the street that is on the right in Figure 18 is not located according to the plans and the arrow points to the curb ramp, rather than being aligned with the direction of...
-
Dispersion
Conversely, commenters representing the health care industry pointed out that treatment areas in health care facilities can be very fluid due to fluctuation in the population and other demographic...
-
5.8.1.2.1 Ramped Entry Slope Recommendations
Some Committee members pointed out that these provisions create exceptions from the existing 2010 Standards....
-
4.1.2 Surface Design of Examination Tables and Chairs
In contrast, the Advisory Committee recommends that measurement be taken from the highest point of the transfer surface, irrespective of contours, and with uncompressed foam (Section 5.1.4...
-
Charts, diagrams and illustrations
Be sure to supply any major trends or data points that are highlighted....
-
Requirement 6. Reinforced walls for grab bars.
bars around the toilet, tub, shower stall and shower seat, where such facilities are provided, would meet section 100.205(c)(3)(iii) if reinforced areas are provided at least at those points...
-
1. Sloped Surfaces
Rest one end of the level at the highest point of the sloped surface and lift the other end (see below) until the bubble is in the middle of the tube. This is the “level” position....
-
Personal Assistants and Service Animals
(link is external) Point out in your materials any places that can be used as “relief areas” for service animals (hotels and conference center maps are increasingly including...
-
Visible Alarms—Exception to Section 215.1 of the 2010 Standards
to make alterations if doing so would impose undue financial and administrative burdens on the operation of the multifamily housing project, but must provide for accessibility up to the point...
-
DETR
Height was taken from the ground to the highest point, either chair or person....
-
1.1.4 Walk cross slope
If an obvious change in cross slope occurs between measuring points (such as a steeper driveway crossing a sidewalk), measure a minimum of two cross slopes at the steeper portion, but in...
-
Practical Suggestions for Communicating Effectively
Use visual aids when possible, such as pointing to printed information on a citation or other document....
-
Section 1194.26 Desktop and Portable Computers (Preamble, Section-by-Section Analysis)
This means that the connection points on a system must comply with a standard specification that is available to other manufacturers....
-
Section 37.93 One Car Per Train Rule
We would point that, consistent with the Access Board standards, a rail system using mini-high platforms or wayside lifts is not required, in most circumstances, to “double-stop” in order...
-
Section 37.41 Construction of Transportation Facilities by Public Entities
As mentioned above, the Department intends, in the period before January 26, 1991, to view compliance with section 504 in light of compliance with ADA requirements (this point applies to...
-
11B-233.2 Reserved
. ◼ ETA Editor's Note At this point, the alignment of CBC section numbering with 2010 ADA Standards becomes inconsistent....
-
Communication / Devices / Equipment / Other
In an emergency, I can point to words and letters. I cannot read. I communicate using an augmentative communication device....
-
Section 37.173 Training
Several points of this section deserve emphasis....
-
Behavioral Safety Products #DH410 Cylindrical Ligature Resistant Lever Handle
The escutcheon plate is sloped at a low profile, from the door to the lever handle itself, to eliminate any further ligature points, and maintains extremely tight tolerances. ...
