Grab bars and any wall or other surfaces adjacent to grab bars shall be free of sharp or abrasive elements and shall have rounded edges....
Search Results "Control End Wall"
Filters
Commonly Searched Documents
-
11B-609.5 Surface hazards
-
307 Protruding Objects
Objects mounted on walls and posts can be hazardous to persons with vision impairments unless treated according to the specifications in section 307 for protruding objects....
-
11B-903.4 Back support
The bench shall provide for back support or shall be affixed to a wall along its long dimension....
-
11B-903.4 Back support
The bench shall provide for back support or shall be affixed to a wall along its long dimension....
-
Alternate Roll-in Showers
The revised language clarifies the location of the entry at the end of the long side of the compartment (608.2.3)....
-
R309.2.2 Narrow Sidewalks
When an access aisle is not provided, the parking spaces shall be located at the end of the block face. Advisory R309.2.2 Narrow Sidewalks....
-
7.4.5 Passing Spaces
A passing space must also be provided at the end of any segment of trail that meets the requirements of 7.4, if the full length of the trail does not meet the requirements. ...
-
Finding Balance
Finding Balance This historic civil rights legislation seeks to end the unjustified segregation and exclusion of persons with disabilities from the mainstream of American life. . . ....
-
Appendix B to Part 35—Guidance on ADA Regulation on Nondiscrimination on the Basis of Disability in State and Local Government Services Originally Published July 26, 1991
of the preamble to the final regulation on nondiscrimination on the basis of disability in State and local government services beginning at the heading “Section-by-Section Analysis” and ending...
-
11B-608.2.3 Alternate roll-in type shower compartments
A 36 inch (914 mm) wide minimum entry shall be provided at one end of the long side of the compartment....
-
11B-408.4.1 Car dimensions and doors
Car doors shall be positioned at the narrow ends of cars and shall provide 32 inches (813 mm) minimum clear width....
-
4.34.3(4) Bins
EXCEPTION: Where a function can be performed in a substantially equivalent manner by using an alternate control, only one of the controls needed to perform that function is required to comply...
-
1. Side grab bar
Side grab bar: There is a grab bar on the adjacent side wall that is at least 40 inches long and from 33 to 36 inches above the floor....
-
1g
Is there a horizontal grab bar on the wall opposite the seat as shown in Figure 37(a) above?...
-
6. Grab Bar
Is there a horizontal grab bar on the wall opposite the seat for stabilization and aid in maneuvering while in a shower wheelchair?...
-
§100.205(c)(3)(iii)
(iii) Reinforcements in bathroom walls to allow later installation of grab bars around the toilet, tub, shower, stall and shower seat, where such facilities are provided; and...
-
Beam® Smart Presence™ Application Operations Guide
Learn the basic pilot controls of the Beam application for operating the BeamPro by Suitable Technology...
-
11B-604.8.1.2 Doors
Doors shall be located in the front partition or in the side wall or partition farthest from the water closet....
-
903.4 Back Support
The bench shall provide for back support or shall be affixed to a wall....
-
903.4 Back Support
The bench shall provide for back support or shall be affixed to a wall....
-
Comparison of Transfer Protocols
Obtained Percentiles 5th 25th 50th 75th 95th End...
-
B.
These underlying provisions tell entities the end they must achieve; the reasonable modification provision tells entities how to achieve that end in situations in which normal policies and...
-
5. Toilet centerline
Toilet centerline: The toilet bowl needs to be centered 18 inches from the side wall, so that inmates with disabilities can use the side grab bar....
-
11B-604.8.2.3 Grab bars
A side-wall grab bar complying with Section 11B-604.5.1 shall be provided on both sides of the compartment....
