R218 Doors, Doorways, and Gates (Section-by-Section Analysis) Doors, doorways, and gates to pedestrian facilities such as transit shelters must comply with applicable technical requirements...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
Filters
Commonly Searched Documents
-
R218 Doors, Doorways, and Gates (Section-by-Section Analysis)
-
R306 Pedestrian Street Crossings (Section-by-Section Analysis)
R306 Pedestrian Street Crossings (Section-by-Section Analysis) The technical requirements in R306 address pedestrian signal phase timing and pedestrian street crossings at roundabouts...
-
2.2* Equivalent Facilitation
Departures from particular technical and scoping requirements of this guideline by the use of other designs and technologies are permitted where the alternative designs and technologies...
-
1016.8 Resting Intervals
This section contains the technical requirements for the length (1016.8.1), width (1016.8.2), and slope (1016.8.3) of resting intervals; and for a turning space (1016.8.4) where resting...
-
[A] BUILDING
Any structure used or intended for supporting or sheltering any use or occupancy. Advisory Definition of BUILDING. ...
-
Use Zone
Use Zone - The ground level area beneath and immediately adjacent to a play structure or piece of equipment that is designated by ASTM F 1487 Standard Consumer Safety Performance Specification...
-
Qualifications
Familiarity with the state or local government’s structure, activities, programs and employees....
-
12183(a)(1)
first occupancy later than 30 months after July 26, 1990, that are readily accessible to and usable by individuals with disabilities, except where an entity can demonstrate that it is structurally...
-
12182(b)(2)(A)(iv)
(iv) a failure to remove architectural barriers, and communication barriers that are structural in nature, in existing facilities, and transportation barriers in existing vehicles and rail...
-
Sec.36.402(b)(1)
(1) Alterations include, but are not limited to, remodeling, renovation, rehabilitation, reconstruction, historic restoration, changes or rearrangement in structural parts or elements, and...
-
202.6 Architectural Barrier Removal
Removal of architectural barriers, pursuant to 28 C.F.R. s. 36.304, from buildings, structures or facilities shall comply with this code’s requirements for alterations unless compliance...
-
Vertical Clearance [§502.5]
Van spaces can be grouped on one level of parking structures. ...
-
Vertical Access
An accessible route to stories and mezzanines is required in alterations (or additions) where stairs or escalators are added where none existed previously and major structural modifications...
-
[A] BUILDING
Any structure used or intended for supporting or sheltering any use or occupancy. Advisory Definition of BUILDING....
-
101.3 Intent
The purpose of this code is to establish the minimum requirements to safeguard the public health, safety and general welfare through structural strength, means of egress facilities, stability...
-
BUILDING
Any structure utilized or intended for supporting or sheltering any occupancy. Advisory Definition of BUILDING....
-
General: ADA Standard Section 224.1
Section 224.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for transient lodging guest rooms.
-
[ADA Title III §36.104] Readily achievable
employees; the number, type, and location of its facilities; and 5) If applicable, the type of operation or operations of any parent corporation or entity, including the composition, structure...
-
11B-233.3.1.2.6.4 Test number three, unusual characteristics test
located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or code that require the lowest floor or the lowest structural...
-
604.7 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
604.7 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
Accessible Icon Project
What do inclusive streets, architecture, schools, workplaces, and economic structures look like?...
-
M305.2.4.2 Non-Circular Cross Section
Transfer supports with non-circular cross sections shall have a cross-section dimension of 2 inches (51 mm) maximum and a perimeter dimension of 4 inches (100 mm) minimum and 4.8 inches...
-
609.2.2 Non-Circular Cross Section
Grab bars with non-circular cross sections shall have a cross-section dimension of 2 inches (51 mm) maximum and a perimeter dimension of 4 inches (100 mm) minimum and 4.8 inches (120 mm)...
