[See subsections ...]
Search Results "Surface Slope"
-
Ground and Floor Surfaces [4.5]
-
ADA Solutions, Inc. Radius Tactile Detectable Warning Surface
The Surface Applied Radius Tactile is used to retrofit over an existing concrete substrate and can be installed in as little as 10 minutes....
-
5.4.6 Transfer Support Gripping Surface Cross Section for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
5.4.6 Transfer Support Gripping Surface Cross Section for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position....
-
17. If a soil stabilizer was installed as part of the trail surface material, please indicate the product name.
If a soil stabilizer was installed as part of the trail surface material, please indicate the product name....
-
Expert Report of James L.E. Terry, Evan Terry Associates, LLC (August 9, 2018)
Drop-off: The surface slope in the vehicle pull-up space is not level in all directions and exceeds the maximum slope allowed of 1:48 (1991 ADA Stds 4.6.6; ADA Stds 503.4)....
-
11B-505.10.3 Bottom extension at stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance equal to one tread depth beyond the last riser nosing. ...
-
BOAT LAUNCH RAMP
[DSA-AC] A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water....
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
-
Where do I measure for a handrail extension?
A variation of the "horizontal" phrase is when the plane of the handrail extension is parallel to the slope of the stair flight and extends an extra tread from the bottom nosing. ...
-
402 Accessible Routes
Section 402 lists the various elements that can be part of an accessible route: walking surfaces, doorways, ramps, elevators, and platform lifts....
-
Parking Spaces for Vehicles Other Than RVs [F244.2.3.2.2]
Parking spaces for vehicles other than RVs within camping units with mobility features must comply with the following technical requirements for width, surface, and slope....
-
31. Please indicate the number of the complete replacements of the trail surface that you have already performed
Please indicate the number of the complete replacements of the trail surface that you have already performed (in total, so far):...
-
1017.10 Trailhead Signs
This section requires trail information signs at trailheads to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and...
-
ADA Solutions, Inc. Cast in Place Tactile Surface
concrete Cast-In-Place Tiles have a 1/4" nominal thickness and feature embedment ribs 3" on center through entire length of tile Plastic sheeting protection covers entire surface...
-
M305.1 General
Supports shall comply with M305.
-
M305.1 General (Section-by-Section Analysis)
This is an introductory section.
-
M305.1 General
Supports shall comply with M305, as applicable.
-
T402.8.2 Deployment to Boarding Platforms
The running slope of ramps and bridgeplates used for deployment to platforms shall be 1:8 maximum, as measured to the boarding platform with the non-rail vehicle resting on a flat surface...
-
Expert Report of John Rife Torkelson, theACCESSpartnership, L.P. (August 8, 2018)
Parking: The surface slope of the designated accessible van space exceeds the maximum slope allowed of 1:48 (1991 ADA Stds 4.6.3; 2010 ADA Stds 502.4)....
-
Gamco Surface Mounted Hand Dryer - DR-5128
Description Surface-mounted ADA (American Disabilities Act) compliant dryer, with stainless steel with brushed finish....
-
Pilot Rock SRP Saddleback Bike Rack Surface Mount
Model SRP Saddleback Bike Racks are SURFACE mounted by means of a bolt down base plate....
-
Original research for ANSI A117.1 (1957 - 1961)
Buildings and Facilities Accessible to, and Usable by, the Physically Handicapped, ramps were assessed for flatness based on measuring 18 - inch increments on both edges of the ramped surface...
-
Gamco Surface-Mounted Robe Hook Satin - 76717
Description (Formerly model 5153) Surface-mounted robe hook shall be type-304 stainless steel with satin-finish....
-
1011.2 Clear Ground Space
This section requires a clear ground space to be provided at outdoor constructed features and includes specific provisions for the size and location (1011.2.1), surface (1011.2.2), slope...
