The running slope of ramps and bridgeplates used for deployment to the roadway or to curb-height boarding and alighting areas shall be 1:6 maximum, as measured to ground level with the non-rail...
Search Results "Surface Slope"
Commonly Searched Documents
-
T402.8.1 Deployment to Roadways or to Curb Height Boarding and Alighting Areas
-
1016.4 Passing Spaces
Where passing spaces and resting intervals overlap, the technical requirements for resting intervals in 1016.8.3 require the slope of the surface to not be steeper than 1:48 in any direction...
- AJW Architectural Products U590 1.6 Gallon Sanitary Napkin Disposal w/ Keyed Access Panel - Surface Mounted
- ADA Solutions, Inc. Surface Applied Truncated Dome Detectable Warning Systems
-
Re: American Specialties 9014 Surface Mounted Horizontal Baby Changing Station
The design of the hand hold is completely sloped at about 45 degrees. My fingers slipped off unless I applied tremendous pinching force to operate....
- Bradley Surface Mounted Stainless Steel Sheet Tissue Dispenser 515
- Bradley High Capacity Surface Mounted Seat Cover Dispenser 583
- Bradley Surface Mounted Stainless Steel Toilet Tissue Dispenser 5402
- Jacknob Corp. 6049 Latch & Keeper Surface Mounted Partition Hardware
-
1014.2.1 Transfer Access
The surface of the clear ground space is required to be firm and stable, and to slope not steeper than 1:48 in any direction....
-
Amusement Rides
Word Fillable Form (0.8MB) Word Non-Fillable Form (0.7MB) PDF Non-Fillable Form (0.5MB)
- Jacknob Corp. 7033 Surface Mounted Self-Closing Hinge Set
-
35. Please indicate any unusual events that occurred during the last quarter that affected the surface of the trail
Please indicate any unusual events that occurred during the last quarter that affected the surface of the trail (e.g., inclement weather conditions, major program use, special events, etc...
-
11B-809.8 Doors
The floor or landing at primary entry doors, required exit doors, and secondary exit doors where a change in elevation occurs between the interior and the exterior surface of the floor or...
-
Tent Pads and Tent Platforms
Do not allow the slope of an accessible tent pad or platform to exceed 1:48 (2 percent) in any direction, except when the surface isn't paved or built with boards, the slope may be up to...
-
AVAILABLE DATA DO NOT SUPPORT DEPARTING FROM THE CURRENTLY ACCEPTED STANDARD OF 19-INCH TRANSFER SURFACE HEIGHT
tried to determine what the optimal accessible transfer surface height is based on available data....
-
Manual vs. Power (RMS Values)
The different slopes of the linear trend lines show that manual WCs will have a greater increase in vibrations for a particular increase in surface roughness than power WCs....
- World Dryer VERDEdri™ Surface-Mounted Hand Dryer
-
1016.1 General
The technical requirements address the surface of outdoor recreation access routes, passing spaces, and resting intervals (1016.2); the clear width of outdoor recreation access routes (1016.3...
-
1009.2.2 Seat Location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
CURB RAMP
A sloping pedestrian way, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face....
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....