Five Knuckle - Full Surface Swing Clear Hinge BB1266 - Ball Bearing - Heavy Weight Description: - ANSI A8321 - Beveled surface leaves - Non-rising removable pin with...
Search Results "Surface Slope"
-
Hager Companies Five Knuckle - Full Surface Swing Clear Hinge BB1266
-
Hager Companies Five Knuckle - Half Surface Swing Clear Hinge BB1270
Five Knuckle - Half Surface Swing Clear Hinge BB1270 - Ball Bearing - Heavy Weight Description: - ANSI A8421 - Beveled surface leaf - Non-rising removable pin with button...
-
Hager Companies Three Knuckle - Full Surface Swing Clear Hinge AB7523
Three Knuckle - Full Surface Swing Clear Hinge AB7523 - Concealed Anti-Friction Bearing - Heavy Weight Description: - ANSI A8321 - Beveled surface leaves - Non-rising...
-
Hager Companies Three Knuckle - Half Surface Swing Clear Hinge AB7534
Three Knuckle - Half Surface Swing Clear Hinge AB7534 - Concealed Anti-Friction Bearing - Heavy Weight Description: - ANSI A8421 - Beveled surface leaves - Non-rising removable...
-
Tent Pads and Tent Platforms
Do not allow the slope of an accessible tent pad or platform to exceed 1:48 (2 percent) in any direction, except when the surface isn't paved or built with boards, the slope may be up to...
-
1009.2.2 Seat Location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
CURB RAMP
A sloping pedestrian way, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face....
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
Manual vs. Power (RMS Values)
The different slopes of the linear trend lines show that manual WCs will have a greater increase in vibrations for a particular increase in surface roughness than power WCs....
-
1016.1 General
The technical requirements address the surface of outdoor recreation access routes, passing spaces, and resting intervals (1016.2); the clear width of outdoor recreation access routes (1016.3...
-
11B-809.8 Doors
The floor or landing at primary entry doors, required exit doors, and secondary exit doors where a change in elevation occurs between the interior and the exterior surface of the floor or...
-
Outdoor Conditions [4.8.8]
Exterior ramps must be designed so that water does not accumulate on the ramp or landing surface. A slope up to 2% is allowed at landings for adequate drainage....
-
Passing Spaces [1016.4]
When passing spaces and resting intervals overlap, the technical requirements for resting intervals apply and the slope of the surface must be no steeper than 1:48 (2 percent) in any direction...
-
18. If a soil stabilizer was not used, please indicate the application method and material(s) used to achieve the natural surface
If a soil stabilizer was not used, please indicate the application method and material(s) used to achieve the natural surface....
-
Expert Report of Ken Schoonover, P.E., KMS Associates, Inc. (August 7, 2018)
Parking: The surface slope in the designated accessible parking space and access aisle is not level in all directions and exceeds the maximum slope allowed of 1:48 (1991 ADA Stds 4.6.3;...
-
CURB RAMP
A sloping pedestrian way, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face....
-
Instrumentation for Analysis
Upon installation, the playground owner completed a questionnaire (Appendix B) on the type, size and intended age group of the playground, the total cost for the equipment, surface materials...
-
Bobrick B-279 ClassicSeries® Surface-Mounted Waste Receptacle
B-279 ClassicSeries® Surface-Mounted Waste Receptacle Satin-finish stainless steel. Bottom edges hemmed for safety....
-
Bobrick TrimLineSeries ADA Surface-Mounted Hand Dryer B-7128.115V
Durable, 22-gauge galvanized steel with exposed surface, type 304 satin-finish stainless steel cover having #4 satin-finish vertical grain with black plastic trim, automatic sensor, dual...
-
505.10.3 Bottom Extension at Stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
-
505.10.3 Bottom Extension at Stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
