When changes in level do occur, they shall be beveled with a slope no greater than 1 unit vertical in 2 units horizontal (50-percent slope)....
Search Results "Floor Slope"
Commonly Searched Documents
-
1131A.1 Changes in level not exceeding ½ inch
-
505.1 General
Handrails are not required on walking surfaces with running slopes less than 1:20....
-
Rise
The maximum length of a run is determined by the rise (30 inches maximum) and the slope: Max. Rise Slope Max. Length Max. Rise Slope Max....
-
11B-308.3.1 Unobstructed
Where a clear floor or ground space allows a parallel approach to an element and the side reach is unobstructed, the high side reach shall be 48 inches (1219 mm) maximum and the low side...
-
1017.10 Trailhead Signs
requires trail information signs at trailheads to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and maximum running slope...
-
Standard Stall
Recommendation: Ceiling-mounted partitions are a good idea because toe clearance is not interrupted by vertical supports [sic] Because floor-mounted toilets commonly project further...
- Hill-Rom Liko® M220 / M230 Mobile Lift, Senior Video
-
11B-813.2.1.3 Height and operation
Adult changing table height shall be adjustable from 17 inches (432 mm) above the floor or ground to 38 inches (965 mm) above the floor or ground, as measured to the top of the changing...
-
Wading pools. (Section-by-Section Analysis)
Section 242.3 of the 2004 ADAAG provides that newly constructed or altered wading pools must provide at least one sloped means of entry to the deepest part of the pool. ...
- Mayer-Rothschild Foundation: Determination of Grab Bar Specifications for Independent and Assisted Transfers in Residential Care Settings
-
11B-411.2.1.3.4 Position
The face of individual elements or group of individual elements that are operated by user input shall slope away from the user at 15 to 25 degrees from the vertical plane. ...
-
1134A.6, Item 5
When a threshold is used, it shall be a maximum of 2 inches (50.8 mm) in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from...
-
Transits and construction lasers
Transits and construction lasers are useful for setting or measuring overall elevation points to determine a total slope....
-
Original research for ANSI A117.1 (1957 - 1961)
Both slope and cross slope were measured. These guidelines for measurement were deleted from later versions of the standard....
-
1134A.6, Item 5
When a threshold is used, it shall be a maximum of 2 inches (50.8 mm) in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from...
-
11B-809.10.6.5 Thresholds
Where provided thresholds shall be 2 inches (51 mm) maximum in height and have a beveled or sloped angle not exceeding 1 unit vertical in 2 units horizontal (26.6 degrees from the horizontal...
-
Mirrors: ADA Standard Section 603.3
Section 603.3 covers the current ADA Standards for mirrors in toilet and bathing rooms.
-
Unobstructed: ADA Standard Section 308.3.1
Section 308.3.1 covers the current ADA Standards for unobstructed side reach.
-
11B-603.3 Mirrors
Mirrors located above lavatories or countertops shall be installed with the bottom edge of the reflecting surface 40 inches (1016 mm) maximum above the finish floor or ground....
-
11B-603.4 Coat hooks, shelves and medicine cabinets
Shelves shall be located 40 inches (1016 mm) minimum and 48 inches (1219 mm) maximum above the finish floor....
-
City of XXX – ADA Transition Plan
Solution Target Date Person Responsible Cost Estimate Source of Fund South Entrance ramp 1:9 slope...
-
Sight Lines
A variety of factors determine the quality of "vertical" sight lines, such as the distance from performance areas, row spacing, staggering of seats, and floor slope....
-
Gurney Accessible Bathroom
Slip-resistant tile (.6 CFR wet and dry) with multiple grout lines for traction Floor tile installed at a 2% slope for drainage Flexible threshold for easy use from a wheelchair...
-
Changes in Level [§303]
Changes in Level [§303] Changes in level can be up to ¼” without treatment or ½” if beveled with a slope no steeper than 1:2....