Sidewalks & Walkways: The cross slope in the designated accessible route exceeds the maximum slope allowed of 1:48 (1991 ADA Stds 4.3.7; 2010 ADA Stds 403.3)....
Search Results "Floor Slope"
Filters
Commonly Searched Documents
-
Expert Report of Jeromy G. Murphy, American Construction Investigations, LTD (August 6, 2018)
-
11B-402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared...
-
402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared...
-
402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared...
-
11B-402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared...
-
11B-405.9.1 Reserved.
[2010 ADA Standards] 405.9.1 Extended Floor or Ground Surface....
-
1.0 APPLICATION
Where existing individual site furnishings are altered or replaced, the floor or ground surface under or around them is not required to be altered solely because an accessible furnishing...
-
Common Requirements (R304.5) (Section-by-Section Analysis)
Surface slopes that meet at grade breaks must be flush. A maximum cross slope of 2 percent is specified for curb ramps, blended transitions, and turning spaces....
-
1017.10 Trailhead Signs
Typical and maximum running slope; and 5. Typical and maximum cross slope....
-
1017.10 Trailhead Signs
Typical and maximum running slope; and 5. Typical and maximum cross slope....
-
Boost Your Business - Chapter 10 - Restroom Fixtures
Boost Your Business - Chapter 10 - Restroom Fixtures
-
Location
The slope along the accessible route should not be greater than 1:12 in the direction of travel....
-
Technical Infeasibility
plumbing, life safety or other codes (such as when combining two toilet stalls to create an accessible stall would violate the plumbing code’s required fixture count); meeting slope...
-
Location
The slope along the accessible route should not be greater than 1:12 in the direction of travel....
-
11B-403.7 Continuous gradient
The slope of the resting area in all directions shall be 1:48 maximum. ETA Editor's Note CBC requirement 11B-403.7 is not present in the 2010 ADA Standards....
-
General: ADA Standard Section 306.2.1
Section 306.2.1 of the ADA Standards covers information in the current ADA Standards for toe clearance.
-
11B-206.2.3 Multi-story buildings and facilities
For example, a 3-story office building with 4500 sf on the first floor, 2500 sf on the second floor and 1500 sf on the third floor would not qualify for the exception because one of the...
-
11B-402.2 Components
Accessible routes shall consist of one or more of the following components: walking surfaces with a running slope not steeper than 1:20, doorways, ramps, curb ramps excluding the flared...
-
11B-306.2.1 General
Space under an element between the finish floor or ground and 9 inches (229 mm) above the finish floor or ground shall be considered toe clearance and shall comply with Section 11B-306.2...
-
Spectrum Aquatics Gallatin Water Powered Assisted Access Lift
The Gallatin pool and spa lift requires no more than 12″ of total depth (deck to floor/bench) for proper installation....
-
11B-411.2.1.3.4 Position
Keypads or buttons shall slope away from the user at 15 to 25 degrees from the vertical plane....
-
11B-411.2.1.3.4 Position
Keypads or buttons shall slope away from the user at 15 to 25 degrees from the vertical plane....
-
Willoughby Industries ETW-1490-FM-HC Floor Mount Wall Outlet Rear Mounted ADA Blow Out Type Flush Toilet
Requires the Premium User plan or above. (Login or upgrade your account!) -
Safe Harbor
The 1991 Standards permitted controls to be 54 inches maximum above the floor. The 2010 Standards specify controls to be 48 inches maximum above the floor....
