The vertical distance is 10 feet (3050 mm) between the elevation where the gangway departs the landside connection and the elevation of the pier surface at the lowest water level....
Search Results "Vertical Clearance"
Commonly Searched Documents
-
11B-1003.2.1 Boat slips
-
11B-206.2.8 Employee work areas
However, passenger elevators used for vertical transportation between stories are not considered "work area equipment" as defined in Chapter 2, Section 202. ◼...
- Corbin Russwin Inc. ED3000 Series Crossbar Exit Device
- Landscape Forms Inc. FGP Trash Receptacle
- Hollaender ADA Handrail Systems: Grabrail (ADA Rail)
- PEMKO 5 5/16" Latching Panic Saddle Threshold No. 273x224-FGT
-
902 Dining Surfaces and Work Surfaces
Some commenters also recommended a higher minimum height of 29 inches instead of 28 inches to allow a more comfortable knee clearance. Response....
-
11B-805 Medical care and long-term care facilities
Touch screen units shall be allowed to be vertically mounted with the centerline of the display screen no more than 52 inches above the floor in compliance with Section 11B-707.7.1.1....
-
Resting Intervals [1016.8]
The vertical alignment of the ORAR, turning space, and resting interval must be nominally planar (i.e., as flat as possible) so that all the wheels of a mobility device touch the ground...
-
Dune Crossings [1018.10]
The technical requirements for dune crossings do not address the vertical pickets provided in some handrail designs....
-
1. Typical Issues for Individuals Who Use Wheelchairs, Scooters, or other Mobility Devices
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Transit Stops (R308.1) (Section-by-Section Analysis)
Boarding platforms at transit stops must be positioned to coordinate with vehicles to minimize the vertical and horizontal gaps....
-
1010.1.7 Thresholds
Raised thresholds and floor level changes greater than ¼ inch (6.4 mm) at doorways shall be beveled with a slope not greater than one unit vertical in two units horizontal (50-percent slope...
- Kawneer North America AA™250/425 Thermal Entrances
-
1118B.6
If the side reach is over an obstruction, the reach and clearances shall be as shown in Figure 11B-5D(c)....
-
Automatic Doors and Power Assisted Doors [4.13.12]
Some power-assists are activated by opening the door manually (and must meet ADAAG requirements for maneuvering clearance in 4.13.6 and opening force in 4.13.11) while others may be activated...
-
Designed Use
For example, pack and saddle stock require higher and wider clearances than do hikers, so a trail managed for both foot travel and horse use would have a designed use of "Pack and Saddle...
-
Kitchen Counters, Walls, and Floors
Staggered stud construction to prevent noise transmission to other rooms Zero clearance kitchen entries with less than 1/4” change of elevation throughout the accessible route. ...
-
3.3.10 90-Degree Turn
While all of the standards compared in this report have requirements for “wheelchair turning spaces”, only the U.S. and Canada have requirements specifically for 90-degree or L-Turn clearances...
-
Clear Floor Space: Minimum Clear Floor Space Required - Manual, Power & Scooter
The clear floor area width dimension also informs the minimum clearance width for successful passage through corridors, doorways, and wheelchair ramps....
-
§ 38.77(b)
Handrails shall be placed to provide a minimum 11/2 inches knuckle clearance from the nearest adjacent surface....
- Pilot Rock AFT Series - End Accessible Traditional A-Frame Picnic Table - Using Recycled Plastic
- Pilot Rock AFT Series - End Accessible Traditional A-Frame Picnic Table - Using Lumber
- Kohler® Mazz Single-Handle Pull-Down Sprayer Kitchen Faucet in Vibrant Stainless