(2) Assess the extent and scope of any likely violation, by determining which areas of operation are likely to be affected by those policies and practices, such as stages of the loan application...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
Filters
Commonly Searched Documents
-
§100.143(b)(2)
-
4.1.1 General
prohibits full compliance with a specific requirement for clear floor or ground space surface slope, size, or location, the clear floor or ground space shall comply with requirements to the extent...
-
Section 35.151 New Construction and Alterations (Section-by-Section Analysis)
Department will add a new section, designated as § 35.151(a)(2), to provide that full compliance with the requirements of this section is not required where an entity can demonstrate that it is structurally...
-
Stowage of Wheelchairs and Mobility Aids
One commenter asserted that the requirement to carry power wheelchairs in the baggage compartment was inconsistent with ICAO technical standards and IATA dangerous goods rules....
-
11B-809.8.1 Door Thresholds
Secondary exterior door thresholds, including sliding door tracks, shall be 3/4 inch (19.1 mm) high maximum with a 1:2 maximum slope....
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
D. M304 Diagnostic Equipment Used by Patients in a Standing Position
M304 provides the technical requirements for diagnostic equipment used by patients in a standing position....
-
Viewing Areas [F246.3]
Within viewing areas, at least 20 percent, but no less than one, of each type of outdoor constructed feature must comply with the applicable technical requirements for the feature....
-
Overview of FSTAG Implementation Process:
**Refer to FSTAG for detailed instructions, definitions, and technical provisions 7.0 through 7.3....
-
Uniform Federal Accessibility Guidelines (UFAS)
DOJ also uses UFAS for certain special-use facilities when the ADA Standards have no scoping or technical provisions, such as for prisons and jails....
-
238.2.1 Teeing Grounds
forward teeing ground shall not be required to be one of the teeing grounds on a hole designed and constructed so that a golf car can enter and exit the teeing ground where compliance is not feasible...
-
201.4 Scope of Coverage
This code applies to fixed or built-in elements of buildings, structures, site improvements and pedestrian routes or vehicular ways located on a site....
-
206.2.3.1 Stairs and Escalators in Existing Buildings
In alterations and additions, where an escalator or stair is provided where none existed previously and major structural modifications are necessary for the installation, an accessible route...
-
§382.3 Facility
., structures, roads, walks, parking lots, ticketing areas, baggage drop-off and retrieval sites, gates, other boarding locations, loading bridges) normally used by passengers or other members...
-
11B-203.10 Raised refereeing, judging, and scoring areas
Raised structures used solely for refereeing, judging, or scoring a sport shall not be required to comply with these requirements or to be on an accessible route....
-
Definition [F106.5]
A camp shelter is a partially enclosed structure that provides campers and hikers cover from weather and that does not contain plumbing fixtures or kitchen appliances....
-
§8.21(c)(3) Time period for compliance
The recipient shall comply with the obligations established under this section within sixty days of July 11, 1988, except that where structural changes in facilities are undertaken, such...
-
11B-203.10 Raised refereeing, judging, and scoring areas
Raised structures used solely for refereeing, judging, or scoring a sport shall not be required to comply with these requirements or to be on an accessible route....
-
11B-203.10 Raised refereeing, judging, and scoring areas
Raised structures used solely for refereeing, judging, or scoring a sport shall not be required to comply with these requirements or to be on an accessible route....
-
11B-809.10.7.5 Controls
Controls shall be mounted 44 inches (1118 mm) maximum above the finish floor. The force required to activate controls shall be 5 pounds (22.2 mm) maximum....
-
607.4.1.1 Back Wall
Two grab bars shall be installed on the back wall, one located in accordance with 609.4 and the other located 8 inches (205 mm) minimum and 10 inches (255 mm) maximum above the rim of the...
-
504.5 Nosings
The radius of curvature at the leading edge of the tread shall be ½ inch (13 mm) maximum....
-
B. 2004 ADA and ABA Accessibility Guidelines
requirements for facilities covered by the ADA (ADA Chapters 1 and 2); application and scoping requirements for facilities covered by the ABA (ABA Chapters 1 and 2); and a common set of technical...
-
7.4.2 Clear Tread Width
If the condition for an exception prevents achieving the reduced width of 32 inches, comply to the extent practicable....