by patients in a seated position (see M302.2.2), height of breast platforms on mammography equipment used by patients seated in a wheelchair (see M303.4.1), and standing supports in a vertical...
Search Results "Vertical Clearance"
Commonly Searched Documents
-
Other Sources
-
11B-703.7.2.6.3 Unisex toilet and bathing facilities
The vertices of the triangle symbol shall be located 1/4 inch (6.4 mm) maximum from the edge of the circle symbol with a vertex pointing upward....
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
Where a door is provided the symbol shall be mounted within 1 inch (25 mm) of the vertical centerline of the door....
-
1009.7.2 Separation
The fire-resistance-rated construction shall extend vertically from the ground to a point 10 feet (3048 mm) above the floor level of the area for assisted rescue or to the roof line, whichever...
- Diaper Deck Infant Changing Table
- HEWI Hinged Support Rail Duo
- Sargent HP Bored Lock with Push/Pull Trim
- Bobrick Swing-Up Grab Bar B-4998.99
- Just Manufacturing Classroom Concealed Ledgemount Teardrop Handle Faucet
- Just Manufacturing Concealed Classroom Faucet with Triple Radius Spout
-
3.0 Comparison of Research Methodologies
The BS8300:2001 research covered knee and toe clearances, reaching abilities of wheeled mobility users, clear floor area space requirements and maneuvering clearances....
-
UDI
The starting clearance for each trial was the minimum clearance of the Canadian CSA B651-95 Standard....
-
2.0 Methodology
Knee Clearance Height (KCH), Knee Clearance Depth – Upper (KCDU), Knee Clearance Depth – Lower (KCDL) and Extended Depth (ED)....
-
Executive Summary
Key requirements apply to clear floor area, reach limits, knee and toe clearances and maneuvering clearances....
-
11B-805.7 Built-in cabinets and work surfaces
Touch screen units shall be allowed to be vertically mounted with the centerline of the display screen no more than 52 inches above the floor in compliance with Section 11B-707.7.1.1....
-
Forward Approach
The Board sought comment on whether it should require a forward approach, which includes knee and toe clearances below the unit, at all wheelchair accessible drinking fountains (Question...
-
Handrails Requirement
The handrail requirements in section 505 address specifications for continuity, height, clearance, gripping surface, cross section, fittings, and extensions....
-
Comparison of Single-User Toilet Room Layouts: Plan 3
An out-swinging door also minimizes the overall layout depth and cannot swing over the required clear floor space or clearance at any accessible plumbing fixture....
-
604.8.1.2 Doors
Toilet compartment doors, including door hardware, shall comply with 404 except that if the approach is to the latch side of the compartment door, clearance between the door side of the...
-
Facility
Knee and toe clearance complying with 306 shall be providing. (17” min. depth.) 902 Dining Surfaces and Work Surfaces. 902.3 Height....
-
L. Lavatory
Is there at least one lavatory (wash basin) in each public restroom that has each of the following characteristics... ...a 29" high clearance under the front edge and the top of the bowl...
-
G. Chapter 6: Wheelchair Spaces and Securement Systems
The two areas in which the requirements in this chapter differ substantially from the proposed rule—wheelchair space maneuvering clearances and forward excursion barriers for rear-facing...
-
Example of a Single-User Bathroom (with Roll-in Shower)
Where clear floor space at a lavatory is obstructed on both sides more than 2 feet, a clearance at least 36 inches wide is required....
- Kawneer North America 1010C Sliding Mall Front