The referenced technical criteria address the operable parts of windows, including that such parts be within accessible reach ranges, but they do not address the height of glazed openings...
Search Results "Grab Bar Height"
Commonly Searched Documents
-
Operable Parts of Windows
-
212 Sinks, Kitchens, and Kitchenettes
In the proposed rule, this scoping section referenced "wet bars" along with kitchens and kitchenettes....
-
Single Occupant Structures (§203.6)
Single Occupant Structures (§203.6) Single occupant structures accessed only by below-grade passageways or elevated above standard curb height Examples: toll booths that are accessed...
-
§ 38.73(d)(3) Exception
Retrofitted vehicles shall be coordinated with the platform in new and key stations such that the horizontal gap shall be no greater than 4 inches and the height of the vehicle floor, under...
-
§ 38.53(d)(3) Exception
Retrofitted vehicles shall be coordinated with the platform in new and key stations such that the horizontal gap shall be no greater than 4 inches and the height of the vehicle floor, under...
-
407.12.2.1 Unobstructed Side Reach (Section-by-Section Analysis)
Although existing 508 Standards § 1194.25 (j)(2) permits a maximum reach height of 54 inches, it contains the same minimum height (15 inches) and 10-inch reach depth....
-
§ 38.23(c)(5) Slope
If the height of the vehicle floor from which the ramp is deployed is 3 inches or less above a 6-inch curb, a maximum slope of 1:4 is permitted; if the height of the vehicle floor from which...
-
4.3.1 Reference WhMD Users
At minimum, the Reference WhMD Users should have data on unoccupied and occupied length and width, total occupied height, eye height and armrest height....
- Hoyer Presence Heavy-Duty Lift
-
Identification: ADA Standard Section 809.5.5.2
Such peepholes can be placed at a standard height and permit a view from several feet from the door....
-
11B-703.5.7 Stroke thickness
Stroke thickness of the uppercase letter “I” shall be 10 percent minimum and 20 percent maximum of the height of the character. [2010 ADAS] 703.5.7 Stroke Thickness. ...
-
2.7 Tread Obstacles
Where tread obstacles exist on the surface of an ORAR, they shall not exceed 1 inch (25 mm) in height....
-
§ 38.29(f)
(f) For vehicles in excess of 22 feet in length, the minimum interior height along the path from the lift to the securement location shall be 68 inches....
-
3. Medical Diagnostic Equipment
has issued a notice of proposed rulemaking (NPRM) to remove the sunset provisions in the our existing accessibility standards for medical diagnostic equipment (MDE) related to the low-height...
-
1010.1.7 Thresholds
Thresholds at doorways shall not exceed ¾ inch (19.1 mm) in height above the finished floor or landing for sliding doors serving dwelling units or ½ inch (12.7 mm) above the finished floor...
-
BENEFITS AND COSTS: SUMMARY
BENEFITS AND COSTS: SUMMARY Therefore, while establishing these requirements will result in significant costs to health care providers, establishing a lower adjustable height requirement...
-
7.4.6 Tread Obstacles
Tread obstacles on trails shall not exceed 2 inches (50 mm) in height measured vertically to the highest point. ...
-
11B-703.5.7 Stroke thickness
Stroke thickness of the uppercase letter “I” shall be 10 percent minimum and 20 percent maximum of the height of the character. [2010 ADA Standards] 703.5.7 Stroke Thickness....
-
Tread Obstacles on Trails
Where the surface is paved or is built with boards, ensure tread obstacles do not exceed one-half inch (13 millimeters) in height....
-
§ 38.53(d)(2) Exception
New vehicles operating in existing stations may have a floor height within plus or minus 11/2 inches of the platform height....
-
§ 38.73(d)(2) Exception
New vehicles operating in existing stations may have a floor height within plus or minus 11/2 inches of the platform height....
-
Expert opinion on the current knowledge
Transfer boards are a common aid used to facilitate transfers for those who have limited arm strength and/or situations where the height differential between the initial and target seats...
-
ASME
The enclosure walls not used for entry or exit are required to have a grab bar the full length of the wall on platform lifts....
-
Flush Controls on Toilets
If administrative authorities require flush controls for flush valves to be located in a position that conflicts with the location of the rear grab bar, then that bar may be split or shifted...