provided, at least two campsites and one additional campsite for each 100 campsites or fraction thereof, shall be accessed by and connected to sanitary facilities by travel routes with a maximum...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
Filters
Commonly Searched Documents
-
11B-246.2 Camping facilities
-
11B-503.3.3 Marking
The area within the borderlines shall be marked with hatched lines a maximum of 36 inches (914 mm) on center in a color contrasting with that of the aisle surface....
-
505 Handrails
505 Handrails The 2010 Standards add a new technical requirement at section 406.3 for handrails along walking surfaces....
-
M302 Diagnostic Equipment used by Patients in a Seated Position (Section-by-Section Analysis)
M302 in the final rule establishes the technical criteria for diagnostic equipment used by patients in a seated position such as examination chairs....
-
Surface and Slope [1012.4 and 1012.5]
The technical requirements for the surface and slope of parking spaces for vehicles other than RVs are the same as for RV parking spaces....
-
11B-703.7.2.5 Reserved
Repeals technical provisions for use of the cleaner air symbol....
-
APPENDIX D: Provisions of the Architectural Barriers Act Accessibility Standards (ABAAS)
that are referenced in the FSORAG Technical Provisions The ABAAS are available at http://www.access-board.gov/ada-aba/aba-standards-gsa.cfm...
-
Sec.36.506 Alternative means of dispute resolution
Where appropriate and to the extent authorized by law, the use of alternative means of dispute resolution, including settlement negotiations, conciliation, facilitation, mediation, factfinding...
-
§382.83(a)(1)(iii)
a passenger with a disability specified in §382.81 does not make a request at least 24 hours before the scheduled departure of the flight, you must meet the passenger's request to the extent...
-
§382.83(a)(2)(iv)
passenger with a disability listed in §382.81 does not check in at least an hour before the standard check-in time for the general public, you must meet the individual's request to the extent...
-
4.3.4 Tent Pad or Platform Surface
Where a condition for exception in section 1.1 prohibits full compliance, the surface shall comply with 4.3.4 to the extent practicable....
-
4.3.4 Tent Pad or Platform Surface
Where a condition for exception in section 1.1 prohibits full compliance, the surface shall comply with 4.3.4 to the extent practicable...
-
TABLE 601 FIRE-RESISTANCE RATING REQUIREMENTS FOR BUILDING ELEMENTS (hours)
BUILDING ELEMENT TYPE I TYPE II TYPE III TYPE IV TYPE V A B Ad B Ad B HT Ad B Structural...
-
240.2.1 Ground Level Play Components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
11B-240.2.1 Ground level play components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
F240.2.1 Ground Level Play Components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
240.2.1 Ground Level Play Components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
11B-240.2.1 Ground level play components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
11B-240.2.1 Ground level play components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
Future Research Needs
collaborations can foster a national dialog on how accessibility and universal design can be integrated into cultural institutions’ technology strategies and practices and can include feasibility...
-
11B-610.3.1 Rectangular seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall....
-
F238.2.1 Teeing Grounds
forward teeing ground shall not be required to be one of the teeing grounds on a hole designed and constructed so that a golf car can enter and exit the teeing ground where compliance is not feasible...
-
238.2.1 Teeing Grounds
forward teeing ground shall not be required to be one of the teeing grounds on a hole designed and constructed so that a golf car can enter and exit the teeing ground where compliance is not feasible...
-
11B-238.2.1 Teeing grounds
forward teeing ground shall not be required to be one of the teeing grounds on a hole designed and constructed so that a golf car can enter and exit the teeing ground where compliance is not feasible...