Product Data System - V1 - toilet seat cover system Material - Plastic Height - 12.4 in Width - 16.7 in Depth - 2.3 in Color - Black...
Search Results "Character Width (VMS)"
Filters
Commonly Searched Documents
-
Tork Toilet Seat Cover Dispenser
-
ThyssenKrupp Elevator Signa 4 Signal Fixtures
Independent Service, Run/Stop and Hoistway Enable Buttons with black targets, halos with brilliant blue LED illumination and charcoal bezels Black "fishtail" style Braille with white characters...
-
1002.4.4.2 Side Entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
Submerged Depth
Landings must be a minimum of 36 inches in width and 60 inches in length. The sloped entry may be a maximum of 30 feet at 1:12 (8.33%) slope before an intermediate landing is required....
-
1002.4.4.2 Side Entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
5.3.3 Transfer Sides Recommendations for M302
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
1002.4.4.2 Side Entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Edge Protection
Recommendation: At narrow routes in particular, consider maintenance of adjacent surfaces as raised or flush or wider route widths in consideration of minimum maneuvering and passage requirements...
-
Rough Form and Foundation Inspection
slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor spaces are correctly installed so proper slopes, cross slopes, widths...
-
Floor Plan of Elevator Cars [4.10.9]
In alterations, smaller car sizes (minimum 47 inch width and 69 inch length) are permitted in cases of technical infeasibility, including where limited by existing shaft configurations (...
-
Shape and Diameter
A gripping surface width between 1¼ to 1½ inches diameter is specified....
-
Rough Form and Foundation Inspection
slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor spaces are correctly installed so proper slopes, cross slopes, widths...
-
4.34.6.7* OVENS
For side-opening ovens, the door latch side shall be next to the open counter space, and there shall be a pull-out shelf under the oven extending the full width of the oven and pulling out...
-
1.1.12 Ramp cross slope
slope of ramps by establishing elevations at the extreme edges of the ramp at the top and bottom of the ramp and calculate the cross slope at these two locations using the horizontal ramp width...
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-704.2.1.2 Forward approach
If an additional 6 inches (152 mm) in width of clear floor space is provided, creating a clear floor space of 36 inches by 48 inches (914 mm by 1219 mm), the enclosure may extend more than...
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
Two-Way Communication
Section 407.4.9 provides criteria for emergency two-way communication systems in elevator cars which address the height of operable parts and identification by tactile characters....
-
Living Earth Crafts Essex™ Pedicure Chair
options Relaxor heat and massage Wide variety of upholstery and trim color options Power drain pump Pedicure Dimensions Height - 46" (119 cm) Width...
-
Sargent HC 8800 Rim Exit Device
The HC8800 device is designed for standard width stile applications on metal doors. The Hurricane Code Hardware has been accepted by Dade County, Florida....
-
American Safety Tread Co., Inc. Type G500R Stairway Nosing Replacement
Width: 9" Lip: 1-3/8" at 90° angle Thickness: 1/4" Anchor Options: Drilled for screws....
