Where possible, drainage grates should be located outside the minimum clear width of the ORAR....
Search Results "Character Width (VMS)"
Filters
Commonly Searched Documents
-
Openings [1016.6]
-
Maintaining Accessibility in Museum Shops
Museum shops must not allow merchandise to spill into aisles and narrow the width of the accessible route....
-
4.26.2* SIZE AND SPACING OF GRAB BARS AND HANDRAILS
The diameter or width of the gripping surfaces of a handrail or grab bar shall be 1-1/4 in to 1-1/2 in (32 mm to 38 mm), or the shape shall provide an equivalent gripping surface....
-
Clearances for Side Approaches
These clearances, which are permitted to overlap, may determine the width of corridors, including entry alcoves with offset doors....
-
Seeger et al.
Both unoccupied and occupied dimensions of device width and length were measured as well as a set of other basic dimensions....
-
9.5 LOCKER ROOMS
Unobstructed aisle space in front of lockers used by handicapped people shall be a minimum of 42 in (1065 mm) clear width....
-
§ 38.159(b)(7) Platform gaps
Any openings between the platform surface and the raised barriers shall not exceed 5/8 inch (16 mm) in width....
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
III. Handrails and Stanchions
Of course, such a handrail or stanchion cannot encroach upon the required 32 inch width required for the doorway or the route leading to the clear floor space which must be at least 30 by...
-
11B-705.1.2.3 Islands or cut-through medians
Detectable warnings at pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches...
-
11B-406.5.12 Detectable warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
Mockett HK2B-SSS Triple Coat Hook
Size: 8 13/32" overall width, 1 9/16" projection. Mounting kit included. Finish: Satin Stainless Steel....
-
American Specialties Adjustable Tilt Mirror 0600T
Tilts a full 6" (152 mm) with bottom mounted on full width stainless steel piano hinge....
-
Lutron Sivoia QED Kirbé Vertical Motorized Drapery System
Depending on the width of the drapery, brackets can be selected that accept either a roller 64™ or a roller 100 shade drive. Size Tube diameter: 2.56 in....
-
Step 2: Identify the Presence of Limiting Factors
Is the trail tread width 12 inches (227 millimeters) or less for a distance of at least 20 feet (6 meters)?...
-
Destination-Oriented Elevators
(§407.4.8) Visual display of each floor a car has been programmed to stop at and automatic verbal announcement of each car stop are required Visual indicators: ½” min. character...
-
Seating Locations
Remember, when measuring the accessible route through the space, measure the aisle width as if the chairs are pulled out and occupied....
-
11B-608.2.2 Standard roll-in type shower compartments
shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides with a full opening width...
-
Grab Bars
Grab bars must be perpendicular to the pool wall and extend the full width of the wall so a person can use them for support into the water....
-
10.2.1(1)
where a lift or ramp is to be deployed, they shall have a firm, stable surface; a minimum clear length of 96 inches (measured from the curb or vehicle roadway edge) and a minimum clear width...
