Advisory 1002.4.3 Gaps Exception. 36 CFR 1192.83(c) ADA Accessibility Guidelines for Transportation Vehicles - Light Rail Vehicles and Systems - Mobility Aid Accessibility is available at...
Search Results "High Speed Rail"
-
1002.4.3 Gaps
-
Platform Edges
Since the sway of some rail cars may overlap a platform edge, the area of the detectable warning installation should not be considered a safety zone but rather an indication of an adjacent...
-
505.6 Gripping Surface
walking surfaces with slopes not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length where they are integral to crash rails...
-
OBJECTIVES
pedestrian flow would otherwise cause long vehicle delays, where unbalanced traffic volumes require metering to create gaps for entering vehicles, and where signals were needed to accommodate rail...
-
Door and Gate Surfaces [§404.2.10]
ground Existing doors or gates with kick plates (so long as cavities created by kick plates are capped) Tempered glass doors without stiles if the top edge of the bottom rail...
-
Error/Omission: Parts of an accessible route with slopes that exceed 1:20 lack required features including handrails and edge protection.
Wheelchair users may also not be able to climb up the sloped route without railings. Lack of edge protection may result in injury if a wheelchair user rolls off the side of the route....
-
Commuter Bus Service
For example, bus service that is used as a dedicated connecter to commuter or intercity rail service, certain airport shuttles, and university bus systems share many or all of these characteristics...
-
§ 38.159(c)(8) Handrails
The handrails shall be capable of withstanding a force of 100 pounds (445 N) concentrated at any point on the handrail without permanent deformation of the rail or its supporting structure...
-
Table 2
25The requirements analyzed in Table 2 include: sidewalks and other pedestrian circulation paths, pedestrian street crossings, pedestrian overpasses and underpasses, pedestrian at-grade rail...
- American Specialties Turbo-Tuff™ Recessed Mounted Hand Dryer 0134
-
11B-502.6.4.1
The parking space shall be marked with an International Symbol of Accessibility complying with Section 11B-703.7.2.1 in white on a blue background a minimum 36 inches wide by 36 inches high...
-
E. Beds in nursing homes and other care facilities
Beds in nursing homes and other care facilities Nursing homes, assisted living facilities, and other care facilities may have beds that are too high or too low, which can be a problem...
-
4.15.3 Spout Location
The spout shall provide a flow of water at least 4 in (100 mm) high so as to allow the insertion of a cup or glass under the flow of water....
-
M301.4.2 Clearance Around Base
The base of the equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of the examination surface...
-
M302.4.2 Clearance Around Base
The base of the equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of the examination surface...
-
11B-502.6.4.1
The parking space shall be marked with an International Symbol of Accessibility complying with Section 11B-703.7.2.1 in white on a blue background a minimum 36 inches wide by 36 inches high...
- Sunlighten Community Solocarbon® Far Infrared Sauna
- Aurora Doors Sliding Barn Door
- BEA Inc. Jamb Style Door Access PTE (Push To Exit)
-
Common Problems with Entrances and Doors
Ø The door threshold is more than ½ inch high, preventing some people who use wheelchairs from entering....
-
11B-407.2.2.2 Visible signals
The visible signal elements shall be a minimum 2½ inches (64 mm) high by 2½ inches (64 mm) wide. Signals shall be visible from the floor area adjacent to the hall call button....
-
M302.4.2 Clearance Around Base
The base of the diagnostic equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of the examination...
-
M301.4.2 Clearance Around Base
The base of diagnostic equipment shall provide a clearance 6 inches (150 mm) high minimum measured from the floor and 36 inches (915 mm) deep minimum measured from the edge of the examination...
-
Common Problems with New Construction and Alterations
People who use wheelchairs, scooters, crutches, and other with mobility aids often find that both newer and older city and county facilities have parking, routes to and through buildings, high...