[DSA-AC] An elevator call user interface exclusive to a destination-oriented elevator system that requires the user to select a destination floor prior to entering the elevator car....
Search Results "Elevator Car Assignment"
Commonly Searched Documents
-
HALL CALL CONSOLE
-
HALL CALL CONSOLE
[DSA-AC] An elevator call user interface exclusive to a destination-oriented elevator system that requires the user to select a destination floor prior to entering the elevator car....
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
Altering existing elevators. 4. Altering existing steps. 5. Altering existing handrails. 4. ...
-
Elevator Operable Parts
Comment. The proposed rule specified that call buttons be located 35 to 48 inches above the floor (407.2.2). These controls should be held to the basic reach range specifications in...
-
HALL CALL CONSOLE
[DSA-AC] An elevator call user interface exclusive to a destination-oriented elevator system that requires the user to select a destination floor prior to entering the elevator car....
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
Altering existing elevators. 4. Altering existing steps. 5. Altering existing handrails. 4....
-
Re: Co-sharing of Accessible Parking access Aisles by adjacent elevator door allowed?
Pedestrians in the elevator would be stepping directly into a vehicular way upon exiting the elevator cab. How would you address the requirement for detectable warnings? ...
-
§ 38.63 Between-car barriers
[See subsections ...]
-
Height Above Finish Floor or Ground: ADA Standard Section 703.4.1
EXCEPTION: Tactile characters for elevator car controls shall not be required to comply with 703.4.1....
-
QUESTION: WHAT ACCESSIBILITY STANDARDS APPLY TO PASSENGER RAIL CARS WHEN SPECIFIC DESIGN STANDARDS ARE NOT PROVIDED IN 49 CFR PART 38?
ANSWER: This guidance applies to all new and remanufactured passenger rail cars, including rail cars that are in the design phase on the date this guidance is issued....
-
11B-703.3.2 Position
Exception: Braille provided on elevator car controls shall be separated 3/16 inch (4.8 mm) minimum and shall be located directly below the corresponding raised characters or symbols....
-
Position: ADA Standard Section 703.3.2
EXCEPTION: Braille provided on elevator car controls shall be separated 3/16 inch (4.8 mm) minimum and shall be located either directly below or adjacent to the corresponding raised characters...
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
Altering existing elevators. Altering existing steps. Altering existing handrails. 4....
-
LEGAL OPINION - U.S. DEPARTMENT OF TRANSPORTATION OFFICE of GENERAL COUNSEL on 49 CFR 37.43(a)
May 2016
-
§ 37.43(a)
(a)
-
11B-411.2.2.2 Verbal identification
When the accessibility function button is pressed, verbal announcement of the car designation shall be provided at the elevator car entrance upon arrival....
-
11B-411.2.2.2 Verbal identification
When the accessibility function button is pressed, verbal announcement of the car designation shall be provided at the elevator car entrance upon arrival....
-
11B-411.2.2.2 Verbal identification
When the accessibility function button is pressed, verbal announcement of the car designation shall be provided at the elevator car entrance upon arrival....
-
11B-233.3.1.2.5 Multi-story residential dwelling units in buildings with no elevator
In non-elevator buildings in public housing facilities, a minimum of 10 percent but not less than one of the ground floor multi-story residential dwelling units shall be calculated using...
-
Requirement 6. Reinforced walls for grab bars.
Section 100.205(c)(3)(iii) requires that covered multifamily dwellings with a building entrance on an accessible route shall be designed and constructed in such a manner that all...
-
Requirement 6 -- Reinforced Walls for Grab Bars
[See subsections ...]
-
Features of Accessible Parking Spaces
Notes: 1. Parking space identification sign with the international symbol of accessibility complying with 703.7.2.1 mounted 60 inches minimum above the ground surface measured...